Instruction Manual CE28WN3-B CE32WN3-B Colour Television Please read this Instruction book before using your television. We wish you many hours of pleasure from your new television.
SAFETY PRECAUTIONS CAUTION: Please read and retain for your safety. This unit has been engineered and manufactured to assure your personal safety. But improper use can result in potential electric shock or fire hazards. In order not to defeat the safeguards incorporated in this receiver observe the following basic rules for its installation, use and servicing. Installation ! Use ! Do not allow anything to rest on the This television receiver should be power cord.
INSTALLATION 3. You are now ready to switch on. Simply press the Mains ON/OFF switch on the front of the TV set. Mains Supply The TV set is prepared for a mains voltage AC220~240V, 50Hz. Connect the power cord of the TV set to a wall outlet. When the TV set is not to be used for an extended period of time, it is advisable to disconnect the power cord from the power outlet. WARNING! High voltages are used in the operation of this set. Refer service to qualified service personnel.
INSTALLATION Battery Installation Aerial Connections 1. Remove the battery cover by sliding it in direction of the arrow. ■ The aerial socket is located on the back of the TV set. 2. Install two "AA" 1.5 volt batteries so that the "+" and "-" marks on the batteries match the "+" and "-" marks inside the unit. ■ A colour picture of good quality requires a higher aerial signal than a black/white picture.
GENERAL OPERATION Mains ON/OFF Controls P Programme Up / Down Level Up / Down ▲ TV/ Stand-by F MENU/ /OK ▲ ▲ MENU/ TV/ i ■ To turn the TV set ON, press the Mains ON/OFF switch. The power indicator illuminates red to show the power is on. ▼ ▼ P ▲ 1 2 3 WIDE 4 5 6 P P 7 8 9 -/-- 0 CS Menu TV/AV Selection 0~9 0 to 9 Numeric buttons -/-- 2 Digit button P ■ To turn the TV set OFF, press it again.
SOUND FUNCTIONS Volume Adjustment To adjust the sound volume, press the / Sound Effects buttons. Volume Note : If the volume is restricted check Hotel Specification settings on page 17. Main Menu To enter and exit the main menu press the F button on the TV or the Menu button on the remote control unit. Menu Sound Picture Externals More Tuning > > > > > Use the ▲ or ▼ buttons to scroll up and down between menu options.
GENERAL OPERATION Picture Adjustment Menu Sound > Picture > Conexiones Picture > Otros Brightness > Contrast Sintonía Colour Sharpness Effects Format Picture Format To adjust the picture, open the Main Menu by pressing the Menu button and select Picture by pressing the ▲ or ▼ buttons followed by the © button for sub menus. Along with the basic Brightness, Contrast, Colour and Sharpness saturation options, you will find a sub menu with other less common functions and a picture format control function.
GENERAL OPERATION 4:3 Transmission Reception 14:9/16:9 Transmission Reception NORMAL NORMAL NORMAL You will see a black bar, left and right. The viewing ratio is correct, this is how the transmission was intended for viewing. NORMAL AUTO AUTO NATURAL WIDE AUTO You will see a black bar, left, right, top and bottom. The viewing ratio is correct. FULL This automatically stretches the picture so that it fills the width of the screen. This gives a distorted picture where objects appear squashed.
GENERAL OPERATION Letterbox Transmission Reception NORMAL NORMAL AUTO NATURAL WIDE AUTO You will see a black bar, left, right, top and bottom. The viewing ratio is correct, this is how the transmission was intended for viewing. FULL You will see a black top and bottom. The viewing ratio is correct, this is how the transmission was intended for viewing. ZOOM ZOOM ZOOM ZOOM ZOOM ZOOM 14:9 14:9 This automatically zooms into picture (all the arrows relating to the coloured buttons are black).
OTHER FUNCTIONS Externals Menu More Menu This menu includes options referring to SCART connections. ■ Audio 1 OUT/Audio 2 OUT : If your TV set receives a Dual broadcast signal, this menu allows you to select the desired audio output for the relevant connector situated at the rear of the set.
PRESETTING Up to 100 broadcast stations in your reception area can be stored in the electronic memory. There are three ways to preset these channels: ■ AUTO : Searches automatically storing found channels in consecutive programme positions. ■ SEMI : Searches for channels one at a time automatically locking into strong signals. ■ MANUAL : Searches for channels one at a time manually selecting any signal found even if weak.
OTHER FUNCTIONS Alternative Program Press the P P button and the TV set will alternately select the current programme position and the previous programme position viewed. Contrast LEVEL? (1-2-3) You must now select which User level setting to store these settings, by pressing the numeric button 1, 2 or 3. 1 Contrast 23 STORED USER LEVEL 1 Restoring the saved settings Press the button repeatedly to restore either Normal level (Factory settings), User level 1, User level 2 or User level 3.
CONNECTION OF AV EQ UIPMENT Connectors Located on the Rear of the TV Set The rear of the set includes the antenna input line and two SCART or Euro connector connections, with some common features and other features that are unique to each connector. ■ Common Features: - Video signal (CVBS) and stereo audio signal input. - Automatic switching when VCR is in “PLAY” mode, as well as auto selection of 4/3 or 16/9 format if the VCR provides this feature.
VCR USE / OPERATING THE TV WITHOUT THE REMOTE CONTROL Functions for Video cassette This remote control transmitter has been designed to be used in conjunction with selected SANYO VCR’s. Some SANYO VCR’s may have their own functions, so please refer to the individual instruction booklet when using this remote control to ensure compatibility. Operating the TV Without the Remote Control The main TV functions can be operated by using the local keypad situated on the bottom front of the set.
TELETEXT This TV accepts TXT signals until 1.5 level in Flof and Top modes. The internal memory can store 8 pages, that allows an agile access to the information. Teletext Controls Symbol Function Teletext/Mix/TV mode switch 0-9 numeric buttons TXT/TV ▲ TV/ 0-9 /OK F ▲ ▲ MENU/ P▼ P▲ i ▼ ▼ P 33001 2 3 WIDE Previous viewed page 4 5 6 P P 7 8 9 -/-- 0 CS i Index page selection SURROUND 3300 CRICKET TENNIS F.
TELETEXT Sub Page Access Index Page Selection Press the i button to select one of the teletext index pages. P100 CSS....................................PP220011 TOOPPIIINDEX T C S..S NO EW P 255 1 C T P I P 0 N EW S ........................................P S ORR P232 305 0111 1 S O ................... P STT NPP E W EW ATT HEERR............. PP P32 35511 1 W E A H T TRRAAFFFFIICC................
TELETEXT / HOTEL SPECIFICATIONS / SPECIFICATIONS Viewing TV while searching for a page Sometimes the page access can take some time. While waiting you X button. can view the television picture by pressing the TV Specifications Power source AC 220~240V, 50Hz Television system System I Colour system PAL 2. When the page is found, the page number will appear over the television picture. Receiving channel UHF: 21~69 3. Press the AV terminal 21-Pin Terminal 1. Enter the new page number.
SERVICING & HELPFUL HINTS Servicing Your television is fully transistorised and does not contain any user serviceable components. Removal of the cabinet cover may expose you to dangerous voltages. Refer all servicing to qualified service personnel. Unplug the television receiver from the wall outlet and refer servicing to qualified service personnel under the following conditions: ■ If the power cord or plug is damaged. ■ If liquid has been spilt into the television receiver.
WARRANTY TO CUSTOMER Sanyo U.K. Sales Ltd. (the company) warrants to the initial retail purchaser that if this equipment is or becomes defective and that, in the opinion of the Company, the defect is due to faulty material or workmanship the Company will, for a period of 12 calendar months from the date of sale to the original purchaser repair or replace, at its sole option, free of charge, any such defective component part of the equipment, always provided that:- Dear Customer. Thank you for buying SANYO.
Part No. SKP10179-B F7HS/YS SANYO Industries (U.K.) Ltd Printed in U.K.