OWNER'S MANUAL ECD-T1535 PLL Synthesized Stereo Radio with Digital Compact Disc Player • 1 pair of RCA output • CD-R/CD-RW Compatibility • 4 preset Equalization • Auxiliary Input
INSTALLATION Notes: • Choose the mounting location where the unit will not interfere with the normal driving function of the driver. • Before finally installing the unit, connect the wiring temporarily and make sure it is all connected up properly and the unit and the system works properly. • Use only the parts included with the unit to ensure proper installation. The use of unauthorized parts can cause malfunctions.
1. Dashboard 1 6 2. Nut (5mm) 3. Spring washer 4 2 4. Screw (5 x 14mm) 5 3 5. Screw 6. Strap Be sure to use the strap to secure the back of the unit in place. The strap can be bent by hand to the desired angle. (Fig. 2) Removing the unit 1. Frame 1 2. Insert fingers into the groove in the front of frame and pull out to remove the frame. (When reattaching the frame, point the side with a groove downwards and attach it.) 2 3.
HOW TO REMOVE AND INSTALL THE FRONT PANEL (OPTIONAL) 1. Press the release button and pull-off the front panel. Store front panel in the case. 2. To install the front panel, insert the panel into the housing and make sure the panel is properly installed, otherwise, abnormalities may occur on the display or some keys may not function properly.
WIRING CONNECTION MAIN UNIT ANTENNA CONNECTOR IGNITION RED SWITCH (B+) MEMORY YELLOW BACK-UP BLACK GROUND (B–) POWER ANTENNA FRONT Lch SPEAKER REAR Lch SPEAKER (GREY) RCA CABLE Rch RED Lch WHITE BLUE WHITE GREY WHITE/BLACK GREY/BLACK GREEN VIOLET GREEN/BLACK VIOLET/BLACK 5 FRONT Rch SPEAKER REAR Rch SPEAKER
OPERATION 11 7 12 10 1 2 24 3 20 21 5 8 22 14 23 18 19 13 4 9 6 16 15 17 26 25 GENERAL OPERATION • ON/OFF Switch on the unit by pressing any button [except button (7) and eject (4)]. When system is on, press PWR button (9) to turn off the unit. • FACEPLATE RELEASE Press button (7) to detach the removable faceplate.
The adjustment mode will change in the following order: Volume Bass Treble Balance Fader By pressing VOL button + (11) or VOL button – (12), it is possible to adjust the desired sound level. • LOUDNESS Press BND/LOU button (13) for several seconds to reinforce the bass output and display will show “LOUD”. Press it for several seconds again to release this function. • SET THE CLOCK Press the DSP button (15), the clock is shown on the LCD display.
RADIO OPERATION • BAND SELECTION At tuner mode, press BND/LOU button (13) to select the desired band. The reception band will change in the following order: FM1 FM2 FM3 AM • STATION SELECTION Press MANU/SKIP button (16) or MANU/SKIP button (17) to activate automatic seek function. To select manual tuning mode, press for several seconds until “MANUAL” appears on the display.
CD OPERATION • SELECT TRACKS Press MANU/SKIP button (16) or MANU/SKIP button (17) to move to the previous track or the following track. Track number shows on display. button (16) or MANU/SKIP button (17) to fast reverse or Hold MANU/SKIP fast forward. CD play starts from when you release the button. • PAUSE PLAYING Press PAU button (20) to pause CD player. Press it again to resume play. • REPEAT THE SAME TRACK Press RPT button (22) to continuously repeat the same track. Press again to stop repeat.
Note: A. Notes on discs: 1. Attempting to use non-standard shape discs (e.g. square, start, heart) may damage the unit. Be sure to use round shape CD discs only for this unit. 2. Do not stick paper or tape etc., onto the label side or the recording side of any discs, as it may cause a malfunction. 3. Dirt, dust, scratches and warping discs will cause misoperation. B. Notes on CD-Rs (recordable CDs)/CD-RWs (rewritable CDs): 1.
SPECIFICATION GENERAL Power Supply Requirements Chassis Dimensions Tone Controls - Bass (at 100 Hz) - Treble (at 10 KHz) Maximum Output Power Current Drain : DC 12 Volts, Negative Ground : 178 (W) x 165 (D) x 50 (H) : : : : + 10 dB / – 10 dB + 10 dB / – 10 dB 40W x 4 (ch) 15 Ampere (max.) CD PLAYER Signal to Noise Ratio Channel Separation Frequency Response : More than 55 dB : More than 50 dB : 40 Hz - 18 KHz RADIO FM 87.5 to 107.9 MHz 10.
TROUBLE SHOOTING Before going through the check list, check wiring connection. If any of the problems persist after check list has been made, consult your nearest service dealer. Symptom No power. Disc cannot be loaded or ejected. No sound. Sound skips. Cause Solution The car ignition switch is not on. If the power supply is properly connected to the car accessory circuits, but the engine is not running, switch the ignition key to “ACC”. The fuse is blown. Replace the fuse.
SANYO MOBILE AUDIO MODEL ECD-T1535 LIMITED WARRANTY OBLIGATIONS In order to obtain warranty service, the product must be delivered to and picked up from an Authorized Sanyo Factory Service Center at the user’s expense, unless specifically stated otherwise in this warranty. The names and addresses of Authorized Sanyo Service Centers may be obtained by calling the toll-free number listed below.
21605 Plummer Street Chatsworth, CA91311 ECD-T1535. Issue Number 1.