Installation manual

-2-
Turn the Lens Mount Cover counter-clockwise
and take it off by pulling forward. (See Fig. 1)
Fig. 1
Lens Mount Cover
A
Fig. 2
B
A
B
Remove 2 Screws A and loosen 2 Screws B.
Slide the Top Cover forward to take off.
(See Fig. 2)
Top Cover
Turn off the projector, press the Main On/Off
Switch to Off and unplug the AC power cord
from the AC outlet.
Remove the Cover Plate by lifting upwards.
(See Fig. 3)
Fig. 3
Cover Plate
This projector can use three (3) different types
of Light-Block Plates, use the Light-Block Plate
that corresponds to the appropriate optional
lens.
NOTE:
●
The Light-Block Plate FK2A is separated to the
upper and lower plates.
Lower Plate
Upper Plate
DOWN
UP
Insert the lower Light-Block Plate.
(See Fig. 4.)
Fig. 4
■ LENS REPLACEMENT AND INSTALLATION PROCEDURE
1
2
3
4
5
6
NOTE:
●
Make sure the shape of the Light-Block Plate
is correct.
●
Make sure the mark (UP/DOWN and FRONT/
BACK) on Light-Block Plates are correct and
set them properly.
●
Use the following Light-Block Plate.
Light-Block Plate
Type FK2A
(610 337 0064)