Installation manual

-3-
Grasp (release lock) the Lens Lock Lever and
turn it fully upward. (See Fig. 7)
Install the Lens into the projector. Grasp
the Lens Lock Lever and turn the Lever
fu l l y downwa r d un t i l leve r is Lo cke d
(clicked position) properly. (See Fig . 8)
After installing the lens, make sure the lens is
not loose and properly installed.
Fig. 7
LENS LOCK RELEASE
LENS LOCK
Remove the safety lens cap on the rear of the
lens (mounting side). Insert the Lens Attachment
and secure with the four (4) screws (supplied).
(See Fig. 5.)
Connect the Lens Motor Lead to the socket on
the top loght of the Lens Attachment.
(See Fig. 6.)
Lens Attachment
(supplyed with the projector)
Part No. (610 275 6029)
Screw Driver
(supplied with the optional lens)
Lens Attachment 01
POA-LNA-01
Part No. (610 303 8742)
7
8
Lens Attachment
Fig. 5
Fig. 6
Fig. 8
Socket
Connector
Lens Motor Lead
Grasp (unlock)
Lens Lock Lever
and pull upward.
Grasp (unlock)
Lens Lock Lever
and fully pull down-
ward until it is
locked (clicked).