INSTRUCTION MANUAL MCD-ZX540F MCD-ZX541F CD Portable Radio Cassette Recorder 540AU.indd 1 2009.4.
PRECAUTIONS CAUTION-INVISIBLE LASER RADIATION WHEN OPEN AND INTERLOCKS DEFEATED. AVOID EXPOSURE TO BEAM. ADVARSEL-USYNLIG LASER STRÅLING VED ÅBNING, NÅR SIKKERHEDSAFBRYDERE ER UDE AF FUNKTION, UNDGÅ UDS ÆTTELSE FOR STRÅLING. VARNING-OSYNLIG LASER STRÅLNING NÄR DENNA DEL ÄR ÖPPNAD OCH SPÄRR ÄR URKOPPLAD. STRÅLEN ÄR FARLIG. VORSICHT! -UNSICHTBARE LASERSTRAHLUNG TRITT AUS, WENN DECKEL GEÖFFNET UND ENN SICHERHEITSVERRIEGELUNG ÜBERBRÜCKT IST. NICHT, DEM STRAHL AUSSETZEN.
CONTROLS 1 17 18 19 2 15 20 16 21 14 13 5 12 11 10 9 MONO ST FM MODE BEAT CANCEL 24 23 3 4 8 7 6 25 26 22 27 28 29 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. Headphones socket (PHONES) CD Compartment Lid Tuning control (TUNING) Band select switch (BAND) Frequency indicator Record button (REC) Play button (PLAY) Rewind button (REW) Fast forward button (F.
POWER SUPPLY AC Power Caution on batteries To prevent battery electrolyte leakage, which may result in injury and damage to the unit or other objects, observe the following precautions: 1. All batteries must be installed with the proper polarity (see diagram on the rear of the unit). 2. Do not mix new with old or used batteries. 3. Only use batteries of the same type and brand. 4. Remove the batteries when they are not to be used for a long period time. 5.
CD PLAY Use compact discs bearing the symbol shown below. In addition to conventional 12cm CDs, this system can be used to play 8cm CDs without an adapter. Note: Do not open the CD compartment during CD play. Always press the STOP n button and wait for the disc to stop rotating before opening the CD compartment. This unit can play back the CD-R/RW as well. However, some CD-R/RW can not be played back depending on the recording conditions. 1. Set the FUNCTION switch to CD.
Repeat playing mode Press the REPEAT button repeatedly to select a repeat play mode available. Each time the button is pressed, the mode changes as shown below: [CD] “REPEAT” blinks (Repeat one track) 5. Repeat steps 3 - 4 to programme additional tracks. 6. Press the PLAY/PAUSE i button to start playback. “MEMORY” remains lit. MEMORY “REPEAT” appears (Repeat all tracks) When all programmed tracks have been played, the player stops automatically. - The programme contents are retained in memory.
LISTENING TO OTHER SOURCES 1. Connect the audio cable (not supplied) from the audio output socket of a auxiliary equipment to the LINE IN socket. (Stereo Mini Plug: ø3.5) 2. Set the FUNCTION switch to LINE IN. 3. Follow the instructions supplied with the other equipment. Auxiliary equipment LISTENING TO TAPES 1. Set the FUNCTION switch to TAPE/OFF. 2. Press the STOP/EJECT button. The cassette holder opens. 3. Load the cassette into the cassette holder.
LISTENING TO THE RADIO 1. Set the FUNCTION switch to RADIO. 2. Select the desired radio band with the BAND switch. 3. Tune in a desired station by turning the TUNING control. 4. To turn the radio off, set the FUNCTION switch to TAPE/OFF or CD or LINE IN. To improve reception FM: Pull out the telescopic aerial and adjust its position. AM: Rotate the unit. To receive FM stereo broadcasts Set the FM MODE select switch (the back of the unit) to ST.
MAINTENANCE Cleaning the tape heads To ensure continued high performance, use a cleaning tape (available from your local audio dealer) to clean the head block of the deck after about every 10 hours of use. Cleaning the unit Clean the outside of the unit with a clean soft cloth, moistened with lukewarm water. Do not use benzene, thinners, or alcohol for they may mar the finish of the surfaces. Cleaning the CD player lens The lens should never be touched.
SPECIFICATIONS CD player Channels: 2-Channel stereo Sampling frequency: 44.1 KHz Pick-up: Semiconductor laser Laser output: 0.6 mW (Continuous wave max.) Wave length: 790 nm Wow/Flutter: Below measurable limits Radio Reception frequency: FM: 87.5 - 108 MHz AM: 526.5 - 1606.5 KHz General Output power: 2 W/ch (DC max.) 1.5 W/ch (AC max.