Projector User Manual

49
Setting
Ceiling
Rear
Ceiling
When this function is set to “On,” the picture is top/bottom
and left/right reversed. This function is used to project the
image from a ceiling-mounted projector.
Rear
When this function is set to “On,” the picture is left/right
reversed. This function is used to project the image to a
rear projection screen.
Terminal
The COMPUTER IN 2/MONITOR OUT terminal on the back
of the projector is switchable for computer input or monitor
output (p.10). Select Computer 2 or Monitor Out with the
Point 7 8 buttons.
Computer 2……computer input
Monitor Out……monitor out
Terminal function is not available when Computer 2 to the
input source is selected. Change the input source to the
others (Computer1 or Video) so that the Terminal function is
available (pp.27, 37–38).
Input search
This function detects the input signal automatically.
When finding a signal, the search will stop. Use the
Point 7 8 buttons to select one of the followings.
Off …… Input search does not work.
On1 …… Input search works under the situation below.
• When the AUTO SET button on the remote
control is pressed.
On2 …… Input search works under the situation below.
• When the projector is turned on with
pressing the ON/STAND-BY button on the top
control or on the remote control. (After the
countdown)
• When the AUTO SET button on the remote
control is pressed.
•When the current input signal is missed.✳
✳If the No show or Freeze function is active, cancel it
to activate the Input search. It is not available when
On-Screen menu is displayed.
✔Note:
• Input search and Auto PC Adj. cannot be set
to “Off” at the same time.
• While Input search is set On1 or On2, the
status of Input and Lamp are displayed every
time the signal is switched.
• Only the input source selected at the last
time can be detected.
• If the AUTO SET button on the remote
control is pressed while Input search is on,
Input search will stop and go back to the
previous input signal.
• The input source can be switched by
pressing the COMPUTER, VIDEO, S-VIDEO,
COMPONENT, or NETWORK button on the
remote control while Input search is on.
• Sync on Green signal does not support Input
search.
• Input search does not work for Wired/
Wireless Network input sources.
• If the INPUT button on the top control is
pressed while Input search is on, Input
search will stop.
• The Auto PC adjustment function can be
operated directly with the AUTO PC button on
the remote control even when Auto PC adj. is
set to “Off” in the Auto setup setting.
Auto setup
This function enables Input search and Auto PC adjustment
by pressing the AUTO SET button on the remote control.
Settings for those functions can be altered as follows:
Auto PC adj.
On . . . . . Enables Auto PC Adjustment when pressing
the AUTO SET button on the remote control.
Off . . . . . Disables Auto PC Adjustment.