Projector User Manual

10
Part Names and Functions
Rear Terminal
q
w
e
r
t
y
i
u
y S-VIDEO IN
Connect the S-VIDEO output from video
equipment to this jack (p.17).
!0 AUDIO IN
Connect the audio output from video equipment
connected to r, y or o to this jack. [When the
audio output is monaural, connect it to L (MONO)
jack (p.17, 18).
i AUDIO IN COMPUTER
Connect the audio output (stereo) from a computer
connected to w or e to this jack (pp.16, 18).
o VIDEO IN
Connect the composite video output from video
equipment to VIDEO jack (p.17).
e COMPUTER IN 2/MONITOR OUT
This terminal is switchable and can be used for
input from a computer or output to the other
monitor.
Set the terminal up as either Computer input or
Monitor output properly. [Used for Monitor out,
this terminal outputs only incoming signal from
COMPUTER IN 1 terminal (pp. 16, 49)].
u AUDIO OUT(VARIABLE)
Connect an external audio amplifier to this jack
(pp.16-18).
This terminal outputs sound from AUDIO IN
terminal (i or !0).
q SERVICE PORT
This jack is used to service the projector.
w COMPUTER IN 1
Connect output signal from a computer, or RGB
scart 21-pin video output to this terminal (pp.16,
18).
When the cable is of the longer variety, it is
advisable to use this terminal and not COMPUTER
IN 2/MONITOR OUT.
o
t ALARM buttons
Use these buttons when setting up the Alarm
function (pp.55-56).
r COMPONENT IN
Connect the component video output signal to
these jacks (p.18).
!0