Owner's Manual LCD Front Projector PLV-55WHD1, PLV-65WHD1

14
CONNECTING DIGITAL AUDIO OUT
TO A MULTI-CHANNEL RECEIVER
Switch off the LCD Projection TV and external
equipment before connecting cable. (Cable is not
supplied.)
1
Connect the STB’s DVI Output to a “DVI to HDMI
Cable;” then connect the cable to the LCD
Projection TV’s HDMI input.
Note: Check with your local electronics store for a
DVI to HDMI Cable that matches your equipment and
the LCD Projection TV.
2
Connect the STB’s Audio L / R to the LCD
Projection TV’s VIDEO3 Audio L / R.
3
The LCD Projection TV must be turned on first,
press POWER. Then turn on your external
equipment.
4
Press INPUT to select HDMI to view a digital
program.
S-VIDEO
VIDEO
R-AUDIO-L
(MONO)
Y–––––Pb–––––Pr
VIDEO
3
VIDEO
2
AUDIO
OUTPUT
R-AUDIO-L
(MONO)
DIGITAL
AUDIO
OUTPUT
HDMI
R-AUDIO-L
(MONO)
R-AUDIO-L
(MONO)
Y–––––Pb–––––Pr
SET-TOP BOX (Can be a Digital Satellite Receiver,
DVD PLAYER, or similar digital device.)
1
2
■ Press the INPUT key after connecting cables to access the
AV Inputs. There is NO need to tune to a blank channel.
■ With a DVI connection, make sure you connect Audio out to
the LCD Projection TV’s VIDEO3 Audio in.
■ Because the VIDEO3 audio jacks are used to receive the
audio from the DVI device, these video jacks cannot be
used when a DVI device is connected.
■ “No Signal” will appear on the screen when no signal is
detected.
1
4 5 6
2 3
INPUT
POWER
REMOTE CONTROL
4
3
What you will need for connections:
DVI to HDMI Cable – 1
Audio Cable – 1
Dolby® Digital Audio provides 5.1 channels of surround
sound (five full-range channels [5] and one low-
frequency effect channel [.1]). A fiber optics cable is
used to carry the 5.1 surround sound (for low-noise
signal transfer).
1
Using a Fiber Optics cable, connect the LCD
Projection TV’s Digital Audio Output to the Digital
Audio Input of a Multi-Channel Receiver. (Fiber
optics cable is not supplied.)
2
Press POWER to turn on the LCD Projection TV,
then turn on external equipment.
Notes:
When making the connection, do not pinch or kink
the fiber optics cable.
Red light visible at the Digital Audio Output does not
necessarily indicate that Dolby® Digital 5.1 audio is
available. Digital audio is made up of light pulses that
the human eye cannot detect. Dolby® Digital 5.1
audio is available at the Digital Audio Output only
when received as part of a Digital signal.
1
4 5 6
2 3
INPUT
POWER
MULTI-CHANNEL
RECEIVER
OPTICAL
DIGITAL CABLE
1
REMOTE CONTROL
2
What you will need for connections:
OPTICAL Cable – 1
PTV BACK
PTV BACK
IMPORTANT NOTE FOR MONITOR USE:
If you did not connect an antenna, you must run All
Channel Search twice before you can select the AV inputs.
IMPORTANT NOTE FOR MONITOR USE:
If you did not connect an antenna, you must run All
Channel Search twice before you can select the AV inputs.
CONNECTING STB WITH DVI OUTPUT
TO HDMI INPUT
DVI TO HDMI
CABLE
AUDIO
CABLE