Owner's Manual LCD Front Projector PLV-55WHD1, PLV-65WHD1

16
USING THE ANALOG VIDEO1 JACKS TO CONNECT A VCR
(OR OTHER ANALOG DEVICE)
Switch off the LCD Projection TV and external equipment
before connecting cable. (Cable is not supplied.)
1
Connect VCR’s Audio Video Out to the LCD
Projection TV’s VIDEO1 jacks.
Note: For Mono VCR (Single Audio Jack), connect VCR
Audio Out to LCD Projection TV’s AUDIO-L (MONO)
Input.
2
Optional:
Connect VCR’s S-Video Out to the LCD Projection
TV's S-VIDEO In Jack.
Note: S-Video jack connections override VIDEO1 Video
jack connection.
3
Press POWER to turn on the LCD Projection TV,
then turn on external equipment.
4
Press INPUT to select Video 1 to
view the VCR program.
What you will need for connections:
Audio Video Cable – 1
S-Video Cable – 1
Note: Don’t be fooled by the phrase “Available in High-
Definition.” Composite jacks offer only 480i (SDTV)
resolution. To view available High-Definition (HD) programs,
you must connect your HD equipment to the Component or
HDMI jacks.
■ Press the INPUT key after connecting cables to access
the VIDEO1 input. There is NO need to tune to a blank
channel.
■ “No Signal” will appear on the screen when no signal is
detected.
S-VIDEO
VIDEO
VIDEO
2
R-AUDIO-L
(MONO)
R-AUDIO-L
(MONO)
Y–––––Pb–––––Pr
VIDEO
1
PTV BACK
IMPORTANT NOTE FOR MONITOR USE:
If you did not connect an antenna, you must
run All Channel Search twice before you can
select the AV inputs.
1
4 5 6
2 3
INPUT
POWER
REMOTE CONTROL
43
1
2
VCR BACK
S-VIDEO
CABLE
AUDIO
VIDEO
CABLE