Owner's Manual LCD Front Projector PLV-55WHD1, PLV-65WHD1

PRECAUTIONS

To ensure safe operation, please observe the

following precautions:

Use two (2) AAA alkaline batteries, see page 8.

Replace both batteries at the same time. Do not

use a new battery with a used battery.

Risk of explosion, if battery is replaced by an

incorrect type.

If batteries have leaked in the remote control,

carefully wipe the case clean and load new

batteries.

Do not expose the remote control to moisture

or heat.

REMOTE CONTROL KEYS

INPUT Key—Press to change the input signal source

as follows: Analog RF ➡ Digital RF ➡ Video1 ➡

Video2 ➡ Video3 ➡ HDMI ➡ Analog RF.

NUMBER Keys—Two keys must be pressed to

select a direct channel. Example: Press 0 then 6 to

select channel 6.

For Analog Cable channels above 100, press and

hold the 1 key until C1- - appears, then press the

other two numbers.

INFO Key—Press to display the Digital and Analog

Full Banner information (press again to remove the

display).

Digital Full Banner display—Contains a two-part

Channel Number (Major and Minor), and Tuner ID. If

available, the following is also included: Station ID, V-

Chip Program Rating, Program Title, Audio Info, and

Signal Strength.

Tuner ID

Channel

Major Minor

Station ID

Program Rating

Signal StrengthAudio InfoProgram Title

Analog Full Banner display—Contains the Channel

Number (analog antenna/cable), Tuner ID, Station ID

(if available), Program Title (if available), V-Chip

Program Rating, and Audio Info.

Tuner ID Channel No. Station ID Program Rating

Program TitleAudio Info

Point toward

LCD Projection TV

USING THE REMOTE CONTROL