User Manual

- 12 -
When the life of the projection lamp of this LCD Projection TV
draws to an end, the LAMP REPLACE indicator will become
yellow. If this indicator turns to yellow, replace the lamp with a
new one promptly.
LAMP
REPLACE
WARNIN
G
This indicator becomes yellow
when the life of the projection
lamp draws to an end.
Front Panel
Turn off the LCD Projection TV and disconnect the AC plug. Allow
the LCD Projection TV to cool for at least 30 minutes.
Loosen a screw that secure the Lamp Cover with a screwdriver
and remove the Lamp Cover.
1
3
Loosen 2 screws that secure the lamp with a screwdriver and
pull out the Lamp by holding the holes on both sides.
4
Replace the Lamp with a new one and put it back and tighten 2
screws. Make sure that the Lamp is correctly secured into the
Lamp compartment.
5
Press the latches on both side of the front cover and pull the front
cover forward to remove.
2
Connect the AC Power Cord to the Power Cord Connector and
turn on the LCD Projection TV.
Follow these steps to replace the lamp assembly.
Put the Lamp Cover back and tighten the screw, and then replace
the front cover.
6
Reset the Lamp replace counter.
See “Lamp Replace Counter” on the next page .
For continued safety, replace with a lamp of the same
type. Do not drop a lamp or touch a glass bulb! The
glass can shatter and may cause injury.
Allow a LCD Projection TV to cool, for at least 30
minutes before you open the Lamp cover. The inside of
the LCD Projection TV can become very hot.
CAUTIONCAUTION
Loosen the screw
Lamp Cover
CAUTION
When installing the new Lamp into the Lamp compartment, make sure
the Lamp socket is securely plugged into the compartment socket.
Improper or loosen socket connection may cause arc discharge result-
ing fire hazard.
7
8
Part (a)
Part (a)
Loosen the screw
Loosen the screw
LAMP
With pressing
the button, pull
the front cover
forward.
Press the latch
on both side.
Hold here and pull out the lamp.
(There are holes inside)
■ Lamp Replacement