User Manual

16
Installation
Connecting to Video Equipment (Video, S-Video)
SERVICEPORT
HDMI COMPUTER
COMPONENT1
COMPONENT2
VIDEO
S-VIDEO
Pb/CbYPr/Cr
Video Equipment
S-video
Cable
S-VIDEO
Output
S-VIDEOVIDEO
Composite
Video Output
Video Cable
(RCA x 1)
Video, S-video
Use the supplied video cable or a S-video cable (commercially
available).
Note:
When connecting cables, the power cords of both the projector and external
equipment should be disconnected from the AC outlet.
SERVICEPORT
HDMI COMPUTER
COMPONENT1
COMPONENT2
VIDEO
S-VIDEO
Pb/CbYPr/Cr
Video Equipment
Component Video Output
(Y, Pb/Cb, Pr/Cr)
COMPONENT
Component
Use a component cable (optional).
Connecting to Video Equipment (Component)
Component
Cable
(RCA x 3)
✔Note:
• See page 55 for ordering optional cables.
• For the connection between HDTV equipment and projector’s COMPONENT 1/2
terminals, horizontal line noise may be noted only occasionally. In this case, adjust the
value of Fine sync on page 32. The factory default value of Fine sync is “10”. The setting
can be adjusted between 0 to +31.
This projector can be connected up to six equipment at one time. See the figures below for the connections.