User's Manual

55
23
OPTIONAL COMPONENT
For freezer (MTR-4014LH)
1. Remove a cap for the fixing screw on the panel
cover for mounting space of temperature recorder.
2. Remove the fixing screw and open the panel
cover. (Fig. 5)
3. Remove the panel cover by pushing the shaft on
both side outward.
4. Attach the temperature recorder (MTR-4014LH) to
the recorder fixture (MPR-S30: optional component)
by using the enclosed screws. (Fig. 6)
5. Mount the recorder fixture with recorder to the
mounting space in the unit. (Fig. 7)
6. Route the recorder sensor and capillary tube as
shown in the procedure 3 through 8 above and fix
the sensor on the freezer wall (Fig. 8).
Note:
The recorder MTR-4014LH cannot be installed at
the right corner on the top of the cabinet even if the
recorder for refrigerator (MTR-0620LH) is not
installed there.
For both refrigerator and freezer (MTR-G3504)
1. Remove a cap for the fixing screw on the panel
cover for mounting space of temperature recorder.
2. Remove the fixing screw and open the panel
cover. (Fig. 9)
3. Remove the panel cover by pushing the shaft on
both side outward.
4. Attach the temperature recorder (MTR-G3504) to
the recorder fixture (MPR-S7: optional component)
by following the instruction shown in the procedure
enclosed with the fixture.
5. Remove the connector cover. Then connect the
power connector on the recorder to the connector on
the unit side. (Fig. 10)
6. Mount the recorder fixture with recorder to the
mounting space in the unit.
7. Fix the recorder sensor to each chamber by using
clips, as mentioned in the procedure for
MTR-0620LH and MTR-4014LH above.
Shaft
Fixing screw
Cover panel
Fig. 5
Fig. 6
Fig.7
Fig.8
Shaft
Fixing screw
Cover panel
Fig.9
Fig.10
Fig.11