Operation Manual

Model Combinations
Combine indoor and outdoor units only as listed
below.
Indoor Unit Outdoor Unit
Power Source:
50 Hz, single-phase, 220 – 240 VAC
Be sure to connect indoor and outdoor units
only in combinations that are listed in the
combination table(s) included in the outdoor
unit package.
Connecting any other model may result in
operation failure and malfunction.
CAUTION
Español
Français Deutsch Italiano
Português
EEÏÏÏÏËËÓÓÈÈÎο¿
English
85264190479001 © SANYO 2009 SANYO Electric Co., Ltd.
Osaka, Japan
Contents
Page
IMPORTANT!
Please Read Before Starting .................................. 2
1. GENERAL .......................................................... 3
1-1. Tools Required for Installation (not supplied)
1-2. Accessories Supplied with Unit
1-3. Optional Copper Tubing Kit
1-4. Type of Copper Tube and Insulation Material
1-5. Additional Materials Required for Installation
2. INSTALLATION SITE SELECTION ................... 4
2-1. Indoor Unit
2-2. Embedding the Tubing and Wiring
3. HOW TO INSTALL THE INDOOR UNIT ............ 6
3-1. Remove the Rear Panel from the Unit
3-2. Make a Hole
3-3. Install the Rear Panel on the Wall
3-4. Removing and Installing the Grille
3-5. Shape the Indoor Side Tubing
3-6. Wiring Instructions
3-7. Wiring Instructions for Inter-unit Connections
3-8. Mounting
3-9. Drain Hose
4. MULTIPLE SWITCH ON THE REMOTE
CONTROL UNIT INDOOR UNIT TYPES
(SAP-KRV184EH, KRV244EH)
(SAP-KRV186EH, KRV246EH)
(SAP-KRV96EHDS, KRV126EHDS)................. 19
5. HOW TO TEST RUN THE AIR CONDITIONER... 20
6. REMOTE CONTROL UNIT INSTALLATION
POSITION ......................................................... 22
6-1. Mounting on a Wall
7. ADDRESS SWITCH .......................................... 23
7-1. Address Setting of the Remote
Control Unit
8. CONNECTING A HOME AUTOMATION
DEVICE.............................................................. 24
9. INSTALLATION CHECK SHEET ...................... 24
INSTALLATION INSTRUCTIONS
– Inverter Split System Air Conditioner –
COOL/DRY/HEAT Model
This air conditioner uses the new refrigerant R410A.
Be sure to read the yellow instruction sheet
attached to the outdoor unit for models using the
new refrigerant R410A.
The illustrations are based on the typical appearance
of a standard model. Consequently, the shape may
differ from that of the air conditioner that you are
installing.
NOTE
For Indoor Unit
SAP-KMRV74EH
SAP-KMRV94EH
SAP-KMRV124EH
SAP-KMRV76EH
SAP-KMRV96EH
SAP-KMRV126EH
SAP-KRV96EHDS
SAP-KRV126EHDS
SAP-KRV184EH
SAP-KRV244EH
SAP-KRV186EH
SAP-KRV246EH
SAP-CMRV3656EH
08-324 CMRV3656EH_IU EN 6/15/09 5:27 PM Page a