SPECIFICATION Model Power Control SC-B550/B550R/B551 SC-B555/B555T With power control/ Without power control/ HOUSEHOLD USE ONLY
NAME AND FUNCTION OF PARTS (Assemble as indicated in the center illustration.) / When the hose is clogged with dust, remove it in the following manner: 1) Pull out the angled pipe by turning the removal ring in either direction. 2) Use a vinyl garden hose to push out the dust clogging the hose. 3) Insert the angled pipe in place and return the ring to its original position. Do not use the hose without the angled pipe in place.
DUST DISPOSAL / If there is a reduction in suction power, turn off the vacuum cleaner, disconnect the hose and proceed as follows: 1. To separate the dust compartment from the vacuum cleaner, push the clamp button as shown. Dust compartment Clamp button 2. To remove the filter. Caution: Remove the filter slowly to prevent the dust from falling out. 3. Removing the dirt. Caution: If the dust is packed tightly and difficult to remove, lightly tap the dust compartment. 4.
Thank you for your purchase of the Sanyo Vacuum Cleaner. Please read these instructions carefully before using. A FEW PRECAUTIONS 1. Operation without the dust compartment and /or filters in place will allow dust to enter the motor and could damage the vacuum cleaner. 2. Keep the vacuum cleaner away from stoves and other heat sources. Heat can deform and discolor the plastic parts of the unit. 3. Keep the vacuum cleaner free of insecticides.
HOW TO USE THE HOSE STAND / 1 Shorten the extension pipe. Hold here Wind 2 2 Stand the vacuum cleaner up and insert the pipe holder into the pipe-holder hole. Pipe holder 3 Hold the hose and 1 wind it around the pipe. Pipe holder hole Caution Do not carry the vacuum cleaner while it is in the storage position. (Injury or damage may result if the hose or coupling pipe becomes unattached.) FILTER CARE / When the suction power is low and the dust has been discarded, the filter still should be cleaned. 1.
CARE OF TURBO CLEANTM / Before caring for the TURBO CLEANTM , be sure to turn OFF the switch of the unit and disconnect the plug from the outlet. If needles, pins or waste paper get stuck in the suction inlet, remove them after going through the above procedure. Trying to remove them during operation is dangerous. EDGE GRABBER TM / The Edge Grabber system is designed to help clean all the way up to the baseboards. The suction shutter is opened when the floor nozzle is pushed against the wall.
