User Manual

–10–
3-3-2. CASSETTE DRIVE GEAR (See Fig.3-3-3)
1) Refer to section 3-3-1 and remove the cassette mecha-
nism assembly.
2) Remove clamps
and , then remove the gear
holder
.
3) Remove the clamp
, then remove the pinion gear .
4) Remove the clamp
, then remove the lock gear .
ASSEMBLY NOTES:
1. Put the tray in the EJECT mode position before fitting
any parts.
2. Apply grease (VHJ-0100) to the gear mounting shafts,
all the gear teeth, and the cam part of the drive gear
.
3. Ensure that the drive gear, the lock gear and the
pinion gear interlock correctly, as shown in Fig.3-3-2.
4. Make sure the clamps
and snap in to the gear
holder
.
3-3-3.DOOR OPENER, UNDER FRAME AND
STAND L (See Fig.3-3-4)
1) Remove the cassette mechanism assembly, referring
to section 3-1.
2) Remove the two clamps
and take out the under
frame
, pulling it towards you.
3) Press down the tray lock lever
and the lid opener
lever
, and loosen the tray , lifting it away from
you. In this state, press the clamp
and remove the
door opener lever
.
4) Remove the special washer
, then remove the
washer
.
5) Remove the two clamps
and take out the stand L .
Be careful not to exert too much force on the clamps
, as this could cause damage.
ASSEMBLY NOTES:
1. Apply grease (VHJ-0100) to the grooves on the
stand L, the inside of the hole
in the drive shaft ,
and the mounting hole
in the door opener lever of
the stand R.
2. Before fitting the stand L
, be sure to move the
tray
back as far as the EJECT mode position. Put
the two pins
on the tray into the grooves on
the stand L. Put the drive shaft
into the hole .
3. Be sure to fasten the two clamps
and the clamp
on the stand R, and to fasten the two clamps on
the stand L.
Fig.3-3-3
Gear holder
Drive gear
Apply
grease
Tray
Pinion gear
(grease the
outer rim of
the teeth)
Lock gear
(grease the outer rim
of the teeth)
Clamp
Clamp
Fig.3-3-4
Stand R
Hole
Clamp
Under frame
Door opener
lever
Lid opener
lever
Clamp
Clamp
Tray
lock lever
Hole
Washer
Stand L
Clamps
Grooves
Special
washer
Pins
Drive
shaft
Tray