User Manual

–19–
Friction gear
assembly
Fig.3-12-1
3-12. REEL DRIVE MECHANISM
3-12-1.REEL BELT, REEL PULLEY, FRICTION GEAR
ASSEMBLY AND CLUTCH CHANGE LEVER
(See Fig.3-12-1)
1) Refer to section 3-2 and remove the mechanism unit.
2) Remove the reel belt from the reel pulley .
3) Take off the washer
and remove the reel pulley .
4) Take off the washer
and remove the friction gear
assembly
.
5) Remove the clutch change spring
.
6) remove the clamp
gripping the top of the
mechanism chassis, then remove the clutch change
lever
.
ASSEMBLY NOTES:
1. After cleaning the shafts and , apply a drop of oil
(VHJ-0099) to each.
2. Be careful not to get any grease on the reel belt
.
3-12-2.CLUTCH MOUNTING ASSEMBLY
(See Fig.3-12-2)
1) Refer to section 3-3-1 and remove the cassette
mechanism assembly.
2) Refer to section 3-12-1 and remove the reel pulley.
3) Remove the two screws
, then remove the clutch
mounting assembly .
ASSEMBLY NOTES:
1. Align the two holes with the shafts and . Be
careful not to press part A of the clutch mounting
assembly
against the band brake assembly.
2. After assembly, make sure that the clamp on the
clutch change lever has snapped into the chassis.
3-12-3.S SOFT LEVER, SUPPLY REEL ASSEMBLY
AND S REEL GEAR (See Fig.3-12-3)
1) Remove the S soft spring .
2) Remove the clamp
, then remove the S soft lever .
3) Refer to section 3-12-2 and remove the clutch mount-
ing assembly.
4) Refer to section 3-11 and remove the band brake
assembly, then remove the supply reel assembly
, washer and the S reel gear .
ASSEMBLY NOTES:
1. After cleaning the shafts and , apply a drop of oil
(VHJ-0099) to each.
2. After assembly, clean the side of the supply reel
assembly
.
Fig.3-12-2
Fig.3-12-3
Reel belt
Reel pulley
Washer
Washer
Clutch change
spring
Clamp
Clutch change lever
Shaft
Shaft
Hole
Shaft
Shaft
Part A
Hole
Screws
Clutch
mounting
assembly
S soft
spring
Shaft
S reel gear
Supply reel
assembly
Washer
Shaft
Clamp
S soft lever