User Manual

ManualsBrandsSANYO ManualsSecurity ProductsTime Lapse VCR

–21–

Clamp

Brake return spring

Brake control lever

Hole

Cam groove

Clamp

Brake act lever

assembly

Clamp

Shaft

Wheel

gear 1

Clutch change spring

Fig.3-13-2

Fig.3-13-3

3-13-2.BRAKE CONTROL LEVER AND BRAKE ACT

LEVER ASSEMBLY (See Fig.3-13-2)

1) Refer to section 3-2 and remove the mechanism unit.

2) Refer to section 3-15 and remove the wheel gear 2.

3) Refer to sections 3-12-1, then remove the reel belt and

the reel pulley.

4) Remove the clamp

, then remove the wheel gear 1

5) Remove the clutch change spring

6) Remove the clamps

and , then remove the brake

control lever

. Remove the clamp on the topside

of the mechanism chassis.

7) Remove the brake return spring

8) Refer to section 3-8 and remove the worm gear

assembly.

9) Remove the clamp

and clamp , then remove the

brake act lever assembly

. To maintain the perform-

ance of the brake act lever assembly

, do not disas-

semble it.

ASSEMBLY NOTES:

1. Apply grease (VHJ-0100) to the shafts and , to the

teeth of the wheel gear 1

, and to the pin of the

brake control lever

2. Put the pin

of the brake control lever into the

cam groove

of the crescent slide.

3. Before fitting the wheel gear 1

, align the hole

with the hole on the mechanism chassis.

4. Refer to section 3-15 and align the wheel gear 2.

Fig.3-13-4

3-13-3.S BRAKE ACT SLIDE AND BT SPRING

LEVER ASSEMBLY

(See Figs.3-13-3 and 3-13-4)

1) Refer to section 3-16 and remove the crescent slide.

2) Refer to section 3-12-1 and remove the friction gear

assembly.

3) Slide the S brake act slide

in the direction of the

arrow , then remove it.

4) Refer to section 3-11 and remove the BT spring.

5) Remove the sub BT spring

6) Press the BT spring lever assembly

until it touches

the pin

, then remove it.

ASSEMBLY NOTES:

1. Apply grease (VHJ-0100) to the shaft shown in Fig.

3-13-3, and to the BT spring lever assembly

and

the S brake act slide

shown in Fig.3-13-4.

2. After mounting the BT spring lever assembly

the Shaft

, hook the BT spring onto the clamp

and press it until it touches the pin .

3. Make sure that the clamps

, and have snapped

into the S brake act slide

. Align the arrow on

the S brake act slide

with the arrow on the

mechanism chassis.

Clamp

Arrow on

mechanism chassis

Arrow

Clamp

Shaft

Clamp

Sub BT

spring

BT spring

lever

assembly

S brake act

slide

Apply

grease

S brake

act

slide

Apply grease

BT spring

lever

assembly