User Manual

–25–
S
T
3-17. S LOAD GEAR, T LOAD GEAR,
S LOAD LEVER ASSEMBLY AND
T LOAD LEVER ASSEMBLY
(See Figs.3-17-1, 3-17-2 and 3-17-3)
1) Refer to section 3-16 and remove the crescent slide.
2) Refer to section 3-14-2 and remove the S and T incline
mounting assemblies.
3) Remove the clamp
, then remove the components:
the S load gear
, the S load spring and the S load
lever assembly
. When you do this, be careful not to
damage the clamp
, which can be damaged easily.
Again, be careful when you disassemble the compo-
nents, as the S load spring
will spring out.
4) Remove the following components: the T load
gear
, the T load spring , and the T load lever
assembly
. Be careful when you disassemble the
components, as the T load spring
will spring out.
ASSEMBLY NOTES:
1. Apply grease (VHJ-0100) to the shafts , and parts
A shown in Fig.3-17-1. Then apply grease (VHJ-0100)
to the parts shown in Fig.3-17-2.
2. When fitting the S load gear
and the T load gear
align them in the tape-loaded state, as shown in Fig.
A in Fig.3-17-3. Again, after completing tape-unload-
ing on these gears, check that they are positioned as
shown in Fig. B in Fig.3-17-3, then refer to section 3-
14-2 and fit the S and T incline mounting assemblies.
Fig.3-17-1
Fig.3-17-2
Fig.3-17-3
S load
gear
Clamp
S load spring
T load
gear
T load
spring
T load lever
assembly
Shaft
Shaft
Parts A
(apply
grease here)
S load lever
assembly
(T side)
Apply
grease here
Apply
grease inside
the hole
Apply
grease here
(S side)
Apply grease to the gears
Apply
grease
here
Apply
grease here
Apply grease inside
the hole
Fig. A: When tape loading is complete
Fig. B: When tape unloading is complete
T load gear S load gear
S load gear
T load gear