User Manual

–9–
Flat cable
Flat cable
Screw
Screw
Screw
Screw
FE head
connector
ACE head
connector
Dew sensor
connector
Fig.3-2-2
Tray lock
lever
Tray
Lid opener
lever
Fig.3-2-1
3-2. MECHANISM UNIT
(See Figs. 3-2-1 and 3-2-2)
1) Remove the top cover, bottom cover and front cabi-
net assembly.
2) Unplug the flat cable
from the CP-1 PWB
assembly on the cylinder (drum), and unplug the
ACE/FE head connectors
.
3) Unplug the flat cable from the stator.
4) Unplug the dew sensor connector
.
5) Remove the four screws
, then lift up the mechanism
unit. The tray
will stop you removing the two screws
on the front, so release the lock by pressing down
the tray lock lever
and the lid opener lever shown
in Fig.3-2-2, then slide off the tray
. Move the tray by
referring to section 3-1 and turn the loading motor in
the PLAY direction.
3-3. CASSETTE DRIVE MECHANISM
3-3-1.CASSETTE MECHANISM ASSEMBLY
(See Figs.3-3-1 and 3-3-2)
1) Put the VCR into EJECT mode.
2) Remove the two screws
.
3) Lift up the back of the cassette mechanism assembly
slightly, and remove the two hooks on the front.
ASSEMBLY NOTES:
1. The cassette mechanism assembly and the mecha-
nism chassis should both be fitted in EJECT mode.
2. Check that the two hooks
have snapped into the
mechanism chassis, and make sure that the two holes
in the cassette mechanism assembly are aligned
with the two dowels
on the mechanism chassis.
3. Make sure that the big tooth on the pinion gear of
the cassette mechanism assembly slots properly into
the deepest gap in the start rack gear, as shown in
Fig.3-3-2.
4. When fitting the two screws
, use the torque gauge
screwdriver (VHJ-0014). Give the screws a tightening
torque of 5 kg/cm.
Fig.3-3-1
Fig.3-3-2
Drive gear
Start rack gear
Lock gear
Ensure correct
interlocking
Pinion gear
Ensure correct
interlocking
Screws
Mechanism
chassis
Cassette mechanism assembly
Hook
Hole
Hook
Hole
Screws
Dowel