VCR User's Manual

LOCATIONS OF CONTROLS AND INDICATORS
Back Panel
1 RS485 A connector (RJ11 type)
2 RS485 B connector (RJ11 type)
3 DIP switches
œ Used when controlling the VCR through the
RS485 or the RS232C connectors.
4 EXT TIMER IN (external timer input) terminal
5 COM (common) terminal
6 WARNING OUT (warning output) terminal
7 TAPE END OUT (tape end output) terminal
8 SW OUT (switch output) terminal
9 COM (common) terminal
F ALARM OUT (alarm output) terminal
G ALARM IN (alarm input) terminal
H Battery compartment
I VIDEO OUT (video output) jack
J VIDEO IN (video input) jack
K AUDIO OUT (audio output) jack
L AUDIO IN (audio input) jack
M MIC IN (microphone input) jack
N REMOTE (remote control input) jack
O RS232C connector (D-sub 9-pin type)
P AC power input
AUDIO
OUT
MIC IN REMOTE
PUSH
OPEN
EXT
TIMER IN
AC IN ~
IN
VIDEO
IN OUT
RS485 BA
P
1 2 3
COM
WARNING
OUT
TAPE
END OUT
SW
OUT COM OUT IN
ALARM
H
IJKLMN
RS232C
O
ADDRESS
ON
OFF
485
232
EXT
TIMER IN COM
WARNING
OUT
TAPE
END OUT
SW
OUT COM OUT IN
ALARM
456789FG
TERMINATE
ON
OFF
NOTE:
œThis terminal board
may be damaged by
5kg-cm or more torque
and using φ6mm-tip or
more size screwdrivers.
15
96
Pin locations
(male) on the VCR
Pin locations
(female) on the VCR
1 6
NOTE:
Do not connect to
phone line.
RR4Q/EX2 (TLS-9024P GB) Fri. Sept., 29/2000
English 5