Operation Manual

20 2A. Phone Basics
䊳 Press the volume button up or down to adjust the
receiver volume.
䊳 Press MUTE or UNMUTE (left softkey) to switch
between the mute or unmute mode. (Muting
applies to your voice, not the other party’s.)
䊳 Press to turn the speaker on. Press again to
turn it off.
End-of-Call Options
After you have finished your call, the phone will display
an end-of-call message in the Recent History screen
(see page 45). “Call ended” and the duration of the call
will alternately flash beneath the caller’s name (if already
in your Contacts) or the caller’s number (if available).
Press any of the following keys to select an option.
䊳 Press to call a highlighted entry.
䊳 Press to display all history for a highlighted entry.
䊳 Press OPTIONS (right softkey) to display the Recent
History options. (See “History Options” on page 46
for details.)
䊳 Press SEND MESSAGE (left softkey) to send a
message.
䊳 Press to return to standby mode.
䊳 Press or simply wait 10 seconds to return to
where you were before the call (if applicable).
Saving a Phone Number
Your phone can store up to 600 Contacts entries and
each entry can contain up to seven phone numbers.
(See “2D. Contacts” on page 49.)
1. From standby mode, enter a phone number and
press
OPTIONS (right softkey) > Save. (If this is the
first time you are saving an entry to Contacts, skip
to step 3.)
2. Select New Entry or Existing Entry.
3. If you chose New Entry, select a number type, and
then enter the new entry name.
– or –
If you chose
Existing Entry, select an entry to which
you want to save the number, and then highlight a
number type and press .
4. Press DONE (left softkey) to save the entry.
WARNING: Because of higher volume levels, do not place the
phone near your ear during speakerphone use.