Instruction Manual

EN-67
TROUBLESHOOTING GUIDE
Symptom Possible causes Solutions / Corrective Actions
Power does not
turn on.
* The battery has run out.
* The battery is not oriented correctly.
* The battery cover is not closed
properly.
* Load new or fully charged battery.
* Load the battery in the correct direction.
* Close the battery cover correctly.
Camera
suddenly powers
down.
* The function of [Auto Shut
Down] in the mode has
been activated.
* The battery has run out.
* Turn the power back on and set the option of [Auto Shut
Down] to [Off].
* Load new or fully charged battery.
Image is not
captured when the
shutter release
button is pressed.
* The camera is in the or
mode.
* Memory is full.
* Rotate the mode dial to , , , , , or
.
*
Transfer the desired files to your computer and then delete
unnecessary files, or use a different memory card.
Flash does not
fire.
* Flash off is selected in flash
mode.
* 10+2 sec. Self-timer is selected
in self-timer mode.
* The [Capture Mode] is set to
[Burst] or [AEB].
* The camera is in the (video)
mode.
* Select a different flash mode.
* Select [Single] in the [Capture Mode].
* Switch the mode dial to another mode.
Continuous
shooting is not
possible.
* The capacity of the built-in
memory or SD/SDHC memory
card is full.
* Insert SD/SDHC memory card with available space or
delete unwanted images.
Cannot transfer
files over a USB
connection.
* USB cable is not connected
securely.
* USB driver is not installed.
* Camera is turned off.
* Check all connections.
* Install the USB driver on your computer.
* Turn on the camera.