Safety Guide

Please do the following steps to charge:
1. Insert the AC plug of the power adapter into the AC power outlet.
2. Place the battery or the transceiver with battery on the charger.
3. Confirm that the battery contacts are well connected with the charger
contacts, and the charge indicator light turns red, which represent the
beginning of the charging operation.
4. After a period of time, when the indicator light turns green, it shows
the completion of the charging operation.
Installation/Removal of the Battery
1. Installation of the Battery
Please make sure the transceiver is turned off, and then hold the belt clip to open it, Install the two protrusions on
the top of the battery into the aluminum groove of the transceiver as shown by the arrow,Close the battery button
until you hear a "ka" sound. finish installation.
Note: If the battery is not fixed well, please remove it and reinstall.
2. Removal of the battery
To remove the battery, please make sure the transceiver is powered off, Open the belt clip, push the battery button
away, and then remove the battery in the direction of the arrow
MAC
MENU
GROUP
OK
EXIT/
Extension of Battery life
1. The performance of the battery will be reduced when the temperature drops below 0. In cold weather, it is
advised to spare another battery for emergency. Please do not dispose the cold batteries that can not work at low
temperature but may be usable at room temperature.
2. It may affect the normal use or charge of the battery, if it is covered with dust. Please clean the battery with dry
cloth before loading or charging it.
Knowledge about Battery Storage
1. Since the battery will self-discharge, please do charge it fully before putting it aside so as to prevent damages
caused by over discharge.
2. Please take out the battery after storage for some time to fill it, in order to avoid the reduction of the battery
capacity resulting from over discharge. It is proposed for lithium-ion / lithium-polymer batteries to be filled in every
6 months of storage.
3. Please pay attention to the humidity of the battery storage environment. Batteries are supposed to be stored in
the environment of room temperature, cool and dry air, to reduce the self-discharge.
Charging Operation
Please use SAMCOM-specified charger to charge the battery; the indicator light of the charger shows the
completion of charging operation.
Indicator Light State
Red light Be charging
Green light Charging completed