Safety Guide

Please do the following steps to charge:
1. Insert the AC plug of the power adapter into the AC power outlet.
2. Place the battery or the transceiver with battery on the charger.
3. Confirm that the battery contacts are well connected with the charger
contacts, and the charge indicator light turns red, which represent the
beginning of the charging operation.
4. After a period of time, when the indicator light turns green, it shows
the completion of the charging operation.
Installation /Removal of Antenna
1. Installation of the antenna
⑴ Plug the screw-thread end of the antenna into the socket at
the top of the transceiver.
⑵ Rotate the antenna clockwise until tightening up , as shown.
2. Removal of the antenna
Rotate the antenna counterclockwise to remove it.
Installation /Removal of Belt clip
1.Installation of the belt clip
First remove the battery, and then place the clip on the rear top
of the machine, and fix it with two screws by a cross-screw.
Note: Do not install the belt clip unless the battery is off.
2. Removal of the belt clip
As for the removal of the belt clip, please refer to the installation
steps and loose the screws in counterclockwise.
Installation/Removal of External Earphone or Microphone
1. Installation of the external earphone or microphone
(1) Unclose the earphone cap (without removing) in the direction of
the arrow
(2) Insert the earphone or microphone
2. Removal of the external earphone or microphone
You can pull out the external earphone or microphone to remove it.
Note: The use of an external earphone or microphone will affect the waterproof performance of the transceiver.
Operation Guide
b.Meun Selecting List
1、SQL ( Squelch Level Selection ) Setting
After pressing MENU into function menu and choice SQL, press OK key then you can select OFF-9 through by
▲or ▼, then press OK key again, press the EXIT key to give up setting
2、VOX Setting
After pressing MENU into function menu and choice VOX, press OK key then you can select OFF-9 and off
through by ▲or ▼, then press OK key again, press the EXIT key to give up setting. Level 9 small voice can open
transimt.
Installation/Removal of the Battery
1. Installation of the Battery
Please make sure the transceiver is turned off, and then hold the belt clip to open it, Install the two protrusions on
the top of the battery into the aluminum groove of the transceiver as shown by the arrow,Close the battery button
until you hear a "ka" sound. finish installation.
Note: If the battery is not fixed well, please remove it and reinstall.
2. Removal of the battery
To remove the battery, please make sure the transceiver is powered off, Open the belt clip, push the battery button
away, and then remove the battery in the direction of the arrow
MAC
MENU
GROUP
OK
EXIT/
MAC
MENU
GROUP
OK
EXIT/
Item Display Description Setting content
1 SQL Squelch Level Selection OFF 1-9
2 VOX Voice Operation OFF 1-9
3 CMP Voice Compression ON/OFF
4 SCR Scrambler Function ON/OFF
5 SPE Encrypted signaling Settin ON/OFF
6 GRP Group channel setting OFF 1-16
7 CMP Voice Compression ON/OFF
8 BEP Keypad Tone setting ON/OFF
9 USER User name editing
10 REST Reset function YES/ON