User's Manual

B-6 VS-600 Programming
Click Set beside Save options and config to file to upload the current settings to the resident
unit.
B.3.3 Prog./Config. Tab
The Prog./Config. Tab contains programming and configuration settings for the resident unit.
Use this tab to change the desired behaviour when a call goes unanswered, to upgrade the
resident unit software, to configure the unit for use in a common area, or configure whether a call
from the unit can be cancelled by dialling *9 at the destination.
Note: In a majority of installations, these settings do not need to change.
Prog./Config.
Tab
Software upgrade: This section is used to upgrade the resident unit software. It should not be
used unless instructed to do so by Telecor Technical Support.
Delay between dialing the numbers: After dialing a number, the number of seconds to wait
before dialing the secondary or rollover number if the call is unanswered.
Silent: Check the box to make the resident unit dial the phone voice server silently when a
device makes a call. If unchecked, you will hear the DTMF tones while the resident unit dials a
call.
Redial Primary num. (Redial secondary number if primary number does not answer):
Check this box to enable the device to redial or rollover to the secondary number after dialing the
primary number if the primary number does not answer. See the table on the next page for an
explanation of this feature.
Redial Secondary num. (Redial primary number if secondary number does not answer):
Check this box to enable the device to redial or rollover to the primary number after dialing the
secondary number if the secondary number does not answer. See the table on the next page for
an explanation of this feature.