User's Manual

VS-600 Resident Unit Manual B-7
The following table describes the effects of checking the Redial Primary or Redial Secondary
boxes:
Redial
Primary
Redial
Secondary
Result
 
1. Resident unit dials primary number.
2. Resident unit waits for the call to be answered or for the time in delay
to elapse.
3. If the call is unanswered, the resident unit ends the call (hangs up).
; 
1. Resident unit dials primary number.
2. Resident unit waits for the call to be answered or for the time in delay
to elapse.
3. Resident unit dials secondary number.
4. Resident unit waits for the call to be answered or for the time in delay
to elapse.
5. If the call is unanswered, the resident unit ends the call (hangs up).
 ;
1. Resident unit dials primary number.
2. Resident unit waits for the call to be answered or for the time in delay
to elapse.
3. If the call is unanswered, the resident unit ends the call (hangs up).
; ;
1. Resident unit dials primary number.
2. Resident unit waits for the call to be answered or for the time in delay
to elapse.
3. Resident unit dials secondary number.
4. Resident unit waits for the call to be answered or for the time in delay
to elapse.
5. If the call is unanswered, the resident unit dials the primary number
again (goes back to step 1).
Resident “Check-In”: Not used.
“Check-In” time(hour): Not used.
Various Delays (ms): These values are set by default and should not be changed unless
instructed to do so by Telecor Technical Support.
Allow All Wireless: Check this box to allow the resident unit to accept calls from all wireless
devices without needing them to be programmed first. See section B.6 for more information
about configuring a resident unit for use in a common area.
Disable the “ * 9 ”: Check this box to disallow someone from cancelling a call from the resident
unit by dialing *9 at the destination station. Note that *9 can still be used to interrupt the playing
of menu entrées or activity schedules.
Click Get to download the settings from the resident unit.
Click Set to upload the current settings to the resident unit.