User's Manual

C-2 Installation
Material Required: - 8-pin Mas-Con Connector Kits without pigtails (purchased separately, part# CK-
25-8.1-24)
- 3 2-pin Mas-Con Connectors with pigtails (provided)
- Mas-Con Crimping Tool with 0.100” nose (purchased separately, part # MCT)
1
- West-Penn 253 cable (not provided)
To connect the Resident Unit to the Dome Light, complete the following steps:
1. Connect the three 2-pin Mas-Con connectiors with pigtails according to the diagram
below.
2. Using the 8-pin Mas-Con connector, terminate the wires of the West-Penn 253 cable to
the NC1-LD3 dome light according to the diagram below. Connect the green wire to L1,
the red wire to L2, the white wire to L3, and the black wire to C.
3. Connect the wires from the dome light to the pigtails from the resident unit’s dome light
module. Refer to the previous page for a diagram.
1
Telecor offers the Panduit Hand Tool (Part number: MCT-100F), or the Panduit Manual Hand Tool (Part
number: MCT) with Nose Section (Part number: CTD-100F).