Install Manual

The Sapling Company, Inc.
1633 Republic Road
Huntingdon Valley, PA 19006
215.322.6063 P.
215.322.8498 F.
www.sapling-inc.com
5
Setting up the Network Repeater
Initial Setup
1. The Network Repeater is set up to use DHCP by default. Once the Network Repeater is plugged into the switch/router, it will try to get an IP
address automatically.
2. If DHCP is not being used, and a static IP or crossover connection is preferred, then a jumper must be installed on the main board in the
following orientation:
Top View
RJ45 Jack
↓
Jumper must be on
both middle pins for
static IP
3. Static IP - If using a static IP, the IP address will be defaulted to 192.168.0.123. Go to a web browser and type in 192.168.0.123 to load
the web interface. Once this is done, follow the instructions on page 8 to find the Network Settings page. Turn off DHCP and enter the new IP
address and click submit. Then power down the Network Repeater, remove the jumper, and reboot the Network Repeater. To access the web
interface, type in the new IP address in the web browser.
DHCP - If DHCP is being utilized, load the Sapling Monitor software on a PC that is connected to the network. Launch the Monitor.exe file
and follow step 4.
4. Locate the Network Repeater by searching under the “Type” heading. Once it’s located, double click on it to open its web interface.
↓