Owner's Manual

58
© 2021 SAPPHIRE
SAPPHIRE Ice Machine Operator’s Manual
TROUBLESHOOTING
6
PROBLEM POSSIBLE CAUSES SOLUTIONS
The machine won't operate. The ice machine is unplugged.
The ice machine power switch is
OFF.
The ice storage bin is full of ice.
Plug the ice machine in.
Verify that the control unit is
properly programmed.
Take away some ice cubes; make
sure the “ice full” probe is free of
ice.
The compressor works
abnormally with a buzzing noise.
The voltage is lower than
recommended.
Stop the ice machine and do not
restart until the voltage is normal.
The water doesn't feed in after
the ice machine starts.
The water supply tap is turned
o .
The water supply pipe is not
properly connected.
• The water lter is not installed
or not installed correctly.
Turn on the water supply tap.
Reconnect the water supply pipe.
Check that the water lter is
installed correctly.
Machine makes ice, but bin does
not ll up with ice.
The condenser may be dirty.
• The air ow to the ice machine
may be obstructed.
The ambient temperature and
water temperature are high, or it
is near with some heat source.
Clean the condenser.
Check the installation.
Run the unit for a longer period
of time.
Water is leaking out of the unit. A few water droplets are on the
door.
The water supply connection is
leaking.
Under some conditions, humidity
may condense on the door.
Consider moving the unit or just
be more careful when you open
the door.
Tighten water supply hose tting.
Cubes are partially formed and
are white at the bottom.
There is not enough water in the
water bin.
Check if the water supply
pressure is below 15 psi.
Check the water supply. It may be
restricted.
Check for a water leak at the
water trough.
Noise during operation. The feet are not leveled.
Certain sounds are normal.
Level the feet. See “Leveling the
Unit” on page 14.
See “Expecting Normal Sounds”
on page 52.