User's Manual

③ 3.5mm Audio Input
Connect to the supplied lavalier microphone.
④ USB Typc-C Charging Port
⑤ Belt Clip and Standard Cold Shoe Mount
⑥ Volume Control Buttons & Pair Buttons
Operation Guide
For the Blink500 B1/B2 kit
1. Turn on the transmitter TX by long pressing the power key.
2. Turn on the receiver RX by long pressing the power
key.
3. Insert the pairing pin into the pairing pin-hole of RX,
press hard and the pair indicator should be quick
flashing at every 0.5s. Press both the “+” and “-” button
of transmitter TX simultaneously within 10 seconds.
4. The kit will be paired when the RX pair indicator is solid
blue and the TX pair indicator is flashing slowly.
Note: To pair the second transmitter TX, just repeat the
step 3 and 4.
5. Connect the receiver RX to the mic jack of a camera,
camcorder, recorder or mixer with the supplied 3.5mm
TRS audio cable. Or connect the RX to a smartphone or
tablet with the supplied 3.5mm TRS to TRRS audio cable.
6. You are ready to record.
Note: The output of receiver RX is line out. You can
connect it to speaker system. To avoid noise during
connection, before connecting the receiver to a speaker
system, please mute the speaker system and do not use
the headphones.
For the Blink500 B3/B4/B5/B6 kit
1. Turn on the transmitter by long pressing the power key.
2. Plug the RXDi into an iOS device or the RXUC into an USB
Type-C device. Please make sure the antenna (yellow
side) is oriented on the top of the device, when in
landscape mode, to get the best signal.
Volume Functions:
Indicates the volume setting in three stages.
Pairing Functions:
Adjust the audio level by the “+”
and “-” buttons.
Default is in the third stage.
The transmitter mic will be muted
if you turn down the volume till all
the lights are turned off.
Flashing Blue Light (every one
second) = Unpaired
Slow Flashing Blue Light (every
three seconds) = Paired
Successfully