User manual
Table Of Contents
34
Note:
①
Please remove the batteries from the battery
compartment when the device is not used for a long
time.
②
Please always use sets of the same type of battery.
③
Replacing the batteries during operation may generate
noise. Please make sure that the unit is turned off before
replacing batteries.
2. Connect the receiver to the mic jack of a camera,
camcorder or mixer with the supplied cable.
3. Turn on the receiver by long pressing the power button.
4. Set the channel of the receiver by two ways:
①
Using the auto scan function
Use the + or – button to display the auto scan screen on the
receiver.
Long press the SET button to select “Auto scan?”
Press the SET button to confirm.
A
B
The channel with the least noise and interference will be
displayed.