User Manual

/ 26
② 
Manually setting the transmitter channel (Only available on
the UwMic9-TX9 and the UwMic9-TX-XLR9).
• Turn on the transmitter by long pressing the power button.
• Use the + or – button to display the channel setting menu on
the transmitter.
• Long press the SET button to select the menu.
• Use the + or – button to select the same channel as the
receiver and confirm it by short pressing the SET button.
6
Attach the accessories you need for the receiver and
transmitter. Refer to "Attaching Accessories" (page 4,
page10 and page18).
7
You are ready to record.
Specification
Receiver RX9
Channel number 96
Channel group A and B
Oscillator type PLL synthesizer
Audio output connector 3.5 mm mini jack
Antenna 1/4
λ
wire antenna
Audio output level –60 dBV
Headphone output level 30mW (16
Ω
)
Receive frequencies 514 MHz - 596 MHz
Receive sensitivity -95 dBm
Signal to noise ratio 70 dB or more
Voice delay 12 ms
Reference deviation ±5 kHz (–60 dBV, 1 kHz input)
Frequency response 40 Hz to 18 kHz (+/-3dB)
Distortion 0.5% or less