User manual

7
③
Volume indicator
Indicates the volume of audio output.
④
Mute indicator
MUTE ON MUTE OFF
Note: If turn on Mute of the TX, only this TX will
be muted.
⑤
Battery level indicator
Displays the battery level. Please replace the
battery immediately when the indicator starts
flashing.
NOTE: Low battery might cause an unstable
transmission of audio signal.
⑥
Current channel
Displays the current channel number.
NOTE: The channel can only be changed
manually in the RX.
Once the RX is matched with the TX(s), the channel
number of TX(s) will be changed with RX
synchronously all the time.
Volume setting
Long press the SET button to enter the menu.
Use the"+" and "-" to set the volume of output
audio within the range 0 to 31, short press for
exit with saving. The setting is retained even after
the power is turned off.
• Default is "25."
Power locked/ unlocked
Long press the SET button to enter the menu.
Use the"+" and "-" to set unlocked or locked the
power key. Lock the power key to prevent the
receiver being turned off unwittingly while using.
• Unlocked: Long press the power key to turn
on/off the receiver (System default).
• Locked: The receiver will not be turned off
even after pressing the power key.
Mute key enable / disable
Long press the SET button to enable / disable
Mute function.
• Enable: Press power button to turn Mute On /
Off.
• Disable: The audio will not be muted during
using.
• Default is "enable."
Match with RX
• Long press the SET button to enter "Match
with RX". Then, short press to start "Match with
TX" in the RX and "Match with RX" in the TX
simultaneously to match the TX with RX.
• The RX can't match with two or three TXs
simultaneously, please match the RX with TX(s)
one by one.
• According to the chronological order of
matching, the group number of each TX(s) will
be A, B, C by turns.
NOTE: Please match the TX and RX if they
haven’t been matched before
• Once RX and TX has been matched
successfully, the setting is retained even after the
power is turned off
.
The RX and TX will automatically match with
each other everytime after powered on.
• If use another TX, please match the RX with the
new TX.
• When need to relieve TX and RX connection,
select and confirm "Restore default" menu.
Set backlight
Set the backgroud LED light to ON or Delay
60/30/10 seconds or OFF. Default is "Delay 10s."