Instruction Manual

INSTALLATION INSTRUCTIONS FOR
Lever Lock with High Security Lever
Attachment (SL- Prefix)
1
Lock Body Assembly
1. Prep door and install lock bearing and latch according to T-Zone Installation Instructions A7469, steps 1 through 5.
2. Complete assembly of lock with Security Lever Attachment according to the following steps.
2
Security Attachment Screw
1. Using screwdriver provided, unscrew the Security Attachment
Screw from lever catch on the outside sleeve.
IMPORTANT – Keep screw for reinstallation.
2. Install outside and inside sleeves and roses according to
Installation Instructions A7649, steps 6 & 7.
3. PLEASE NOTE – THE CAM IN THE OUTSIDE SLEEVE
MUST BE ROTATED SO THE LARGE SLOT IS HORIZONTAL.
THIS ALLOWS THE SECURITY SCREW TO THREAD INTO
THE CAM.
Insert the Security Attachment Screw into black lever catch
assembly and tighten until screw head is within approximately
1/8" of black lever catch. DO NOT OVERTIGHTEN.
Outside
Sleeve
Lever Catch
Security Attachment Screw
1
3
Screwdriver
3
Lever Installation
1. IMPORTANT: Before installing levers read “SPECIFIC
INSTRUCTIONS PER FUNCTION – BEFORE INSTALLING
LEVER” on page 4 of T-Zone Installation Instructions A7469.
2. Place cylinder in outside lever. Insert key and rotate 45 degrees
clockwise.
3. With key rotated, push lever onto sleeve until hole on
inside of lever is over Security Attachment Screw.
If screw interferes with assembly, check that
screw is fully threaded into black lever catch.
4. Using screwdriver provided, rotate Security
Attachment Screw counter-clockwise until
flush with surface of lever.
5. Secure lever with 6 lobe security screw.
Screw should be flush when properly
tightened.
6. Rotate key to horizontal and remove.
7. Assemble inside lever and secure
with 6 lobe TORX
®
security screw.
2
45°
45°
4
5
6
A7668A
TORX
®
Wrench
3
Cam
Cylinder Removal
1. Remove security screw on outside of lever with TORX
®
wrench.
2. Insert key and rotate key 45° clockwise; keep key in this position.
3. Using screwdriver, tighten the Security Attachment Screw clockwise
until it clears the lever.
4. Remove lever and remove key.
5. Remove cylinder from lever and install new cylinder.
6. Reinstall lever following step 3 above.
45°
1
TORX
®
Wrench
3
2
Copyright © 2009, Sargent Manufacturing Company,
an ASSA ABLOY Group company. All rights reserved.
Reproduction in whole or in part without the express written
permission of Sargent Manufacturing Company is prohibited.
FOR INSTALLATION ASSISTANCE CALL SARGENT AT 1-800-727-5477 • www.sargentlock.com