Manual
SARGENT
®
INSTALLATION INSTRUCTIONS
FOR LEVER LOCK with 50 FUNCTION
(11G50) CYLINDER
FOR INSTALLATION ASSISTANCE, CONTACT SARGENT AT 800-727-5477
1
Lock Body Assembly
1. Prep door and install lock body and roses according to T-Zone Installation Instructions A7469, steps 1 through 7.
2. Assemble cylinder and levers according to following steps.
2
Cylinder Assembly
1. Insert parts into cylinder body as shown in illustration.
2. Slide spring onto indicator pin. Then insert pin into rear of
cylinder body.
3. Insert key block-out bar, round end first
, into cylinder.
4. Slide nylon ring onto back of cylinder.
5. TO PREVENT PARTS FROM SLIDING OUT OF
CYLINDER BODY, KEEP BODY HORIZONTAL OR END
POINTED UP.
3
Lever Installation
1. Place cylinder with assembled parts into outside lever.
2. Put key into cylinder. Making sure the key block out bar is
still within the cylinder, but in the projected position.
3. Gently assemble the cylinder and lever onto the outside
sleeve. Align the spring in the center and two metal
projections at 12 & 6 o'clock with back of cylinder.
4. Push cylinder onto outside sleeve and rotate the key
counterclockwise 45° and hold.
5. Push lever onto lock until lever catch button engages hole in
lever. Secure with 6 lobe security set screw.
IMPORTANT – Check operation of levers and
latch bolt before closing door
Lever catch
button
Nylon ring
Indicator
pin & spring
Key block out bar
This hole must align with
lever catch button to
assemble lever
3
45°
4
2
5
Outside
Inside
Cylinder Removal
1. Remove security screw.
2. Insert key and rotate key 45° counterclockwise.
3. Depress lever catch button and pull lever out
approximately 1/4" to clear lever catch.
4. Rotate key 45° clockwise to horizontal and remove key,
gently removing lever from sleeve.
5. Remove cylinder from lever being careful not to drop
indicator pin or key block-out bar.
6. Install new cylinder.
Lever catch
2
1
Rotate
45°
3
4
3
A7608B
6
4
2
3
6
7
Outside sleeve
Copyright
©
2008, Sargent Manufacturing Company, an ASSA ABLOY Group company. All
rights reserved. Reproduction in whole or in part without the express written permission of
Sargent Manufacturing Company is prohibited.