Owner's manual

1. Align mounting plate with five holes prepared in
door, dimple faces edge of door
2. Install screw and washer from opposite side of door
3. Install four surface screws
4. Assemble rose and tighten
5. Assemble lever
6. Secure with set screw
1. Insert tube assembly into hole in door
2. Insert latch assembly
3. Push aligning pin through tube assembly
and latch assembly
4. Secure latch assembly with two screws
5. Assemble both rose assemblies and tighten
6. Assemble both levers
7. Secure with set screws
4
5
6
3
2
1
DIMPLE
4
5
3
1
1
2
3
5
4
6
6
THREADED HOLE
CLEARANCE HOLE
DIMPLE
DIMPLE
5
5
6
7
3
6
2
4
1
7
DIMPLE
11U93 Single Lever Pull
11U94 Double Lever Pull
11U94-2 Double Lever Pull
INSTALLATION INSTRUCTIONS FOR
Lever Pull Trim
1. Align both mounting flange assemblies with
five holes prepared in door, dimple faces edge
of door
2. Install long screw to secure mounting plates
3. Install eight surface screws
4. Assemble both roses and tighten
5. Assemble both levers
6. Secure with set screws
7
© SARGENT Manufacturing Company A7470A