User guide

2 7
1331 STANDARD APPLICATION JO ARM
INSTALLATION INSTRUCTIONS
Determine maximum degree of door opening required. Use a #16 drill. Drill and tap door and frame for 12-24 machine screws.
When using the included self tapping screw, pre-drill with a 3/32” drill *Provides maximum power for heavy or drafty doors
2
3
4
5
*(120° - 12")
180° - 10-1/8"
*(120° - 6-12")
180° - 4-5/8"
2"
1"
1-3/8"
12"
3/4"
With provided fasteners, install foot to frame and secure
closer body to door with power adjustment
away from hinge
Right hand shown, left hand similar.
2A
++
Move foot
pivot to hole
nearest hinge
For additional power move foot towards hinge
edge of door
Hinge edge of door
On both right and left hand doors, secure main arm to top spindle
with screw and washer provided. Align flat mark as shown
Open door and insert foot into main arm. Close door fully, and while
pushing arm as shown in picture, tighten arm bolt
See page 5 for closer
adjustment and cover
installation
Power Adjustment
Flat mark
Arm
Bolt
90°
A7741A
Copyright
©
2008, Sargent Manufacturing Company, an ASSA ABLOY Group
company. All rights reserved. Reproduction in whole or in part without the express
written permission of Sargent Manufacturing Company is prohibited.
A7741A
Copyright
©
2008, Sargent Manufacturing Company, an ASSA ABLOY Group company. All
rights reserved. Reproduction in whole or in part without the express written permission of
Sargent Manufacturing Company is prohibited.
1