User guide

6 3
*(120° - 3-3/4")
180° - 1-1/4"
Center line
of hinge
12"
3-1/2"
3/4"
With fasteners provided, install foot to stop and closer body to
door with power adjustment toward hinge
With wrench on bottom spindle,
preload/index by turning spindle as
shown and secure main arm to top
spindle with flat mark as indicated at
left with screw and washer
1
1331 JP9 PARALLEL ARM INSTRUCTIONS
2
Right hand shown, left hand opposite.
3
4
Open door and insert foot into main arm. Close door fully while holding elbow 1-1/4” from door. Tighten arm bolt
5
See page 5 for
adjustment and
cover installation
*Provides maximum power for heavy
or drafty doors
1" minimum stop
width required
Accessory Information
2-1/2" Min.
1331D
Drop plate used when
top rail is less than 2 1/2"
Power adjustment
*(120° - 9-12")
180° - 7"
7/16"
2-3/4"
2"
3/8"
3/8"
Center line
of hinge
1-1/4"
Arm Bolt
Left Hand Door
Right Hand Door
Flat mark
Determine maximum degree of door opening required. Use a #16
drill. Drill and tap door and frame for 12-24 machine screws.
When using the included self tapping screws, predrill with a 3/32"
drill.
581-1 Blade Stop Spacer Kit
Metal spacer for use on 1/2" blade
stops on aluminum store fronts
Drop Plate
A7741A
Copyright
©
2008, Sargent Manufacturing Company, an ASSA ABLOY Group company. All
rights reserved. Reproduction in whole or in part without the express written permission of
Sargent Manufacturing Company is prohibited.
A7741A
Copyright
©
2008, Sargent Manufacturing Company, an ASSA ABLOY Group company. All
rights reserved. Reproduction in whole or in part without the express written permission of
Sargent Manufacturing Company is prohibited.