User guide

1431 DOOR CLOSER WITH P10/PH10 ARM

INSTALLATION INSTRUCTIONS

CAUTION: FAILURE TO INSTALL OR ADJUST PROPERLY

MAY RESULT IN INJURY OR DAMAGE.

FOR ASSISTANCE, CALL SARGENT AT 1-800-727-5477

LOCATE AND MARK HOLES USING FULL SIZE TEMPLATE OR

MEASURE AS SHOWN BELOW

RIGHT HAND SHOWN, LEFT HAND OPPOSITE.

PULL SIDE PULL SIDE

PUSH SIDE PUSH SIDE

LEFT HAND DOOR RIGHT HAND DOOR

1431 CLOSER AND P10 ARM ARE NON-HANDED

ONLY THE PH10 ARM IS HANDED

ATTACH FOOT BRACKET TO DOOR STOP.

ATTACH DOOR CLOSER TO DOOR WITH SPRING POWER NUT

TOWARD HINGE.

PRE-DRILL 3/32" HOLES FOR SELF TAPPING

SCREWS OR USE #16 DRILL (DIA.177) AND

TAP #12-24 FOR MACHINE SCREWS

A7387D

* NOTE: FOR MAXIMUM POWER, INSTALL FOR 90° OPENING.

ALTERNATE: PREASSEMBLE ARM PRIOR TO

ATTACHING TO STOP

USE FIFTH HOLE SPACER

WHEN REQUIRED

IMPORTANT: USE A MINIMUM OF 5 SCREWS

HAND

(PH10 ONLY)

Reproduction in whole or in part without the express written

permission of SARGENT Manufacturing is prohibited.

A7387C 1/30/08 3:17 PM Page 1

PAGE 1
A7387C 1/30/08 3:17 PM Page 1 1431 DOOR CLOSER WITH P10/PH10 ARM INSTALLATION INSTRUCTIONS CAUTION: FAILURE TO INSTALL OR ADJUST PROPERLY MAY RESULT IN INJURY OR DAMAGE. FOR ASSISTANCE, CALL SARGENT AT 1-800-727-5477 1 LOCATE AND MARK HOLES USING FULL SIZE TEMPLATE OR MEASURE AS SHOWN BELOW RIGHT HAND SHOWN, LEFT HAND OPPOSITE.
PAGE 2
A7387C 1/30/08 5 3:17 PM Page 2 6 ATTACH ARM TO CLOSER ROTATE BOTTOM SPINDLE WITH WRENCH * A. B. INSTALL MAIN ARM WITH INDEX MARK POSITIONED AS SHOWN BELOW C. SECURE WITH SCREW AND WASHER A. OPEN DOOR AND INSTALL PIVOT AS SHOWN B. USE SCREW TO SECURE PIVOT AND ARMS AS SHOWN A C B MAIN ARM B 6A A ALTERNATE METHOD FOR ATTACHING ARM: A. PREASSEMBLE ARM TO FOOT BRACKET B. MOUNT ARM TO CLOSER AS SHOWN IN STEP 4 C B WARNING: IF NOT PROPERLY INDEXED, DOOR !! * CLOSER WILL NOT FUNCTION PROPERLY.
PAGE 3
A7387C 1/30/08 3:17 PM Page 3 FINAL ADJUSTMENT AND REGULATING PROCEDURES 7 – Adjust Door speed, and Latching speed valves to achieve the desired closing time. Recommend 6 seconds minimum from 90° to the closed position. – If Backcheck is required, adjust valve to achieve a slight cushioning effect. Auxiliary stop required. – If closer is equipped with Delayed Action, regulate valve to achieve the desired delay.