Owner manual

1
2
3
4
5
6
7
8
9
10
14
15
17
18
16
22
20
20
19
11
12
13
21
2
INSTALLATION INSTRUCTIONS FOR
7 Line Lever Lock
For installation assistance,
contact SARGENT at 800-727-5477
www.sargentlock.com
Door Preparation
IMPORTANT:
Fold template onto high
edge of door bevel
38" from
Finished Floor
Template
Door
Bevel
DOOR
FRAME
Backset
must match lock
(2-3/8" or 2-3/4")
• Hollow metal doors should be properly reinforced for lock support. If support is not provided, contact door manufacturer.
• For all metal and wood door preparations, use template 4481. To prepare wood door on site, use template attached.
• Template information is available on our website, www.sargentlock.com
2-1/8"
(54mm)
hole
5/32"
(4mm)
1-1/8"
(29mm)
2-1/4"
(57mm)
1"
(25mm)
hole
Strike
IMPORTANT: Deadlocking latch must
stop on strike when door is closed
• Final Door Prep • Frame Prep for Strike
Parts
1. Inside lever
2. Scalp (2)
3. Screws - self-tapping
(2) #6 x 3⁄4"
4. Screws - through bolt
(2) #8 - 32 x 2-1/8"
5. Inside rose assembly
6. Lockbody
7. Spacer
8. Outside mounting plate
9. Outside rose assembly
10. Cylinder spacer
11. Cylinder retainer
Tools
#2 Phillips screwdriver
Push pin (provided)
1/8" drill bit
5/32" (4mm) drill bit
2-1/8" bore
1" bore
1
Screws (2)
#8-32 x 3/4"
Centerline of
latch front and
strike
Outside of Door (secured side)
Inside of
Door
• Mark and Drill Holes
12. Cylinder
13. Outside lever
14. Key
15. Push pin
16. Latch
17. Screws - latch & strike (4) # 8-32 x 3⁄4"
18. Strike
19. Strike box
20. Bushing for 1-3/8" thick door only
21. Outside mounting plate for 1-3/8"
thick door only
22. Latch Sleeve
Copyright
©
2013, Sargent Manufacturing Company, an ASSA ABLOY Group
company. All rights reserved. Reproduction in whole or in part without the
express written permission of Sargent Manufacturing Company is prohibited.
A7240D