Manual

ManualsBrandsSARGENT ManualsSafetyAL - Alarmed Exit

A7884A • 800-810-WIRE (9473) • www.sargentlock.com

Reproduction in whole or in part without the express written permission of SARGENT Manufacturing is prohibited.

Installation Instructions For

Alarmed Exit Devices

AL- 80 Series

A7224C

5/08

Reproduction in whole or in part without the express written permission of SARGENT Manufacturing is prohibited.

Summary of content (6 pages)

PAGE 1
A7224C 5/08 Copyright © 2008 SARGENT Manufacturing. All rights reserved. Reproduction in whole or in part without the express written permission of SARGENT Manufacturing is prohibited. A7884A • 800-810-WIRE (9473) • www.sargentlock.com 1 2/11/08 Copyright © 2008 SARGENT Manufacturing. All rights reserved. Reproduction in whole or in part without the express written permission of SARGENT Manufacturing is prohibited.
PAGE 2
Table of Contents 1 General Description ............................................................................1 2 Basic Installation Instructions ...........................................................1 3 Cylinder Installation ...........................................................................2 4 Alarmed Exit (AL-) Standard Operating Instructions........................3 5 Options ...............................................................................................
PAGE 3
Alarmed Exit Devices AL-80 Series 1 General Description The SARGENT Alarmed Exit is designed for areas that require an alarm to sound upon exiting. Once armed, any push rail movement will activate the horn in the push rail. The horn will continue to sound for two minutes and then shut off automatically. The LED will flash indicating a violation has occurred.
PAGE 4
Alarmed Exit Devices AL-80 Series 3 Cylinder Installation 1. Prepare door according to template and Alarmed Exit instruction sheet. 2. Verify cylinder (size 41) is installed in rail insert with collar prior to installing exit device on door. SARGENT Collar Cylinder nut To Add or Remove Cylinder 1. Remove Insert Assembly from rail by sliding toward rail end. Side View. Battery holder not shown. Use caution not to damage wires when installing cylinder nut.
PAGE 5
Alarmed Exit Devices AL-80 Series 4 Alarmed Exit (AL-) Standard Operating Instructions To Arm Alarm Turning key clockwise, the yellow PASSAGE LED will flash for 15 seconds (default), then a quick chirp and the ARMED green LED will flash and repeat every 30 seconds. Signal above cylinder indicates unit is armed. NOTE: The unit is automatically armed 15 seconds after the unit is turned on. Field selectable settings listed at bottom of page.
PAGE 6
Alarmed Exit Devices AL-80 Series 5 Optional Settings Continued DS5 ON = GREEN/ARMED, RED/VIOLATION AND YELLOW/ PASSAGE (DEFAULT) OFF= GREEN/VIOLATION, RED/ARMED AND YELLOW PASSAGE.