Owner's manual

17
A7856B • 800-810-WIRE (9473) • www.sargentlock.com
Profile Series v.G1.5 Exit Device
05/04/09 A7856:B Copyright © 2009, Sargent Manufacturing Company, an ASSA ABLOY Group company. All rights reserved.
Reproduction in whole or in part without the express written permission of SARGENT Manufacturing is prohibited.
Mortise Installation Instructions (Continued)
1. Connect ground wire to terminal E3 (Fig. 1), keypad harness to controller (Fig. 2), and ET motor harness to motor
connector (Fig. 3).
2. Place extra wire inside door hole and/or outside escutcheon being careful not to pinch wires.
3. Connectors go on only one way. Do not offset connector and be sure they are completely seated.
Inside of
door
Outside of
door
Ground
wire
ET Motor
harness
Keypad
harness
Outside
of door
Inside
of door
8.5 – Installation of Inside Escutcheon
Fig. 1
Fig. 3
Fig. 2
Note : For RF Technology versions (G1-TU, G1-TP, G1-TA) refer to Section 9 to install through bolt screws.
Note: For RF Technology
version refer to Section 9.
Ribbon Cable Orientation:
Install with cable exiting DOWN, as shown.