Operating instructions

The indicator is available in various ver-
sions. If you have ordered special
options, the indicator will be supplied
with these options premounted at the
factory.
Storage and Shipping Conditions
Allowable storage temperature:
-10 ...+40°C (+14°F ... + 104°F)
– Unpackaged equipment may lose
its accuracy when exposed to strong
vibration. Excessive vibration may
compromise the safety of the
equipment.
– Do not expose the indicator
unnecessarily to extreme temperatures,
moisture, shocks, or vibration.
Unpacking
§ After unpacking the equipment,
please check it immediately for any
visible damage.
$ If you detect any damage, proceed
as directed in the chapter entitled
“Care and Maintenance” under “Safety
Inspection."
$ If you will need to ship your indicator
later, save all parts of the packaging
because only the original packaging
provides the best protection for
shipment.
$ Before shipping, be sure to disconnect
all cables to prevent damage.
Warranty
Do not miss out on the benefits of our
full warranty. Please contact your local
Sartorius office or dealer for further
information. If available, complete the
warranty registration card, indicating
the date of installation, and return the
card to your Sartorius office or dealer.
5
Getting Started
Equipment Supplied
– Indicator
– Operating Instructions (this manual)
– Special accessories listed on the bill
of delivery, if ordered
Setting Up the Indicator
The indicator is designed to provide
reliable weighing results under normal
ambient conditions. When choosing
a location to set up your indicator,
observe the following so that you will
be able to work with added speed and
accuracy:
– Avoid placing the indicator in close
proximity to a heater or otherwise
exposing the indicator to heat or direct
sunlight.
– Protect the indicator from drafts that
come from open windows or doors.
– Avoid exposing the indicator to extreme
vibrations during weighing.
– Protect the indicator from aggressive
chemical vapors.
– Do not expose the indicator to extreme
moisture over long periods.
Turn off the power if you do not
need to use the indicator with other
equipment.
Note:
This equipment has been tested and
found to comply with the limits for
a Class A digital device, pursuant to
Part 15 of the FCC rules. These limits
are designed to provide reasonable
protection against harmful interference
when the equipment is operated in
a commercial environment. This
equipment generates, uses and can
radiate radio frequency energy and, if
not installed and used in accordance
with the instruction manual, may
cause harmful interference to radio
communications. Operation of this
equipment in a residential area is likely
to cause harmful interference in which
case the user will be required to correct
the interference at his own expense.
Changes or modifications not expressly
approved by Sartorius AG could void
the user's authority to operate the
equipment.
Conditioning the Indicator:
Moisture in the air can condense on the
surfaces of a cold indicator whenever
it is brought to a substantially warmer
place. If you transfer the indicator to
a warmer area, make sure to condition it
for about 2 hours at room temperature,
leaving it unplugged from AC power.
Afterwards, if you keep the indicator
connected to AC power, the constant
positive difference in temperature
between the inside of the indicator and
the outside will practically rule out the
effects of moisture condensation.
Seal on Indicators Verified for Use
in Legal Metrology in the EU*:
EU legislation requires that a control
seal be affixed to the verified device.
The control seal consists of a sticker
with the “Sartorius" logo. This seal will
be irreparably damaged if you attempt
to remove it. If the seal is broken, the
validity of the version becomes null
and void, and you must have your scale
re-verified.
* including the Signatories of
the Agreement on the European
Economic Area