Operating instructions

16
Balance Operating Program
The balance operating program lets you adapt your balance to
various ambient conditions and requirements and select weight
units commonly used in your country.
At the factory, we have set the codes for a Standard program,
which is protected by a program lock to prevent accidental
changes.
The
"code"
contains the information of the operating program,
lt consists of three digits known in "computerese" as the "page"
(1
st
digit),the "line" (2
nd
digit) and the "word" (3
rd
digit).
How to access the balance operating program:
With the balance turned off
(STANDBY
state) hold down the
tare control
(13)
while you press the ON/OFF key
(15)
. Upon
completion of the automatic self-test, release the tare control as
soon as
"CH5"
is displayed. The Status of the balance operat-
ing program will be indicated in the weight display.
"L"
Stands for the list mode.
In this mode, you can check the code settings, but you cannot
program new codes. lf you wish to change a program code, you
must first unlock the menu access switch to access the program
menu.
To do so, remove the protective cap located on the lower front
panel on the right of the balance, and slide the menu access
switch
(12)
in the direction of the arrow.
The display will indicate
"C,"
which Stands for the change
mode, meaning you can now change a menu code setting.