Operating instructions

27
Menu 1. through 2. See previous page
3. Application 3.5. Storage parameter 3.5.1 o With stability
parameters 3.5.2 With higher stability
3.6. Reference 3.6.1 Off
sample updating 3.6.2 o Automatic
3.7. Autotare when 3.7.1 Off
[START] key is pressed 3.7.2 o On
5. Interface 5.1. Baud rate 5.1.1 150 baud
5.1.2 300 baud
5.1.3 600 baud
5.1.4 o 1,200 baud
5.1.5 2,400 baud
5.1.6 4,800 baud
5.1.7 9,600 baud
5.2. Parity 5.2.1 Mark
5.2.2 Space
5.2.3 o Odd
5.2.4 Even
5.3. Number of 5.3.1 o 1 stop bit
stop bits 5.3.2 2 stop bits
5.4. Handshake mode 5.4.1 Software handshake
5.4.2 o Hardware handshake,
1 character after CTS
5.4.3 Hardware handshake,
2 characters after CTS
5.5. Communications 5.5.1 o PC, YDP03 printer (SBI)
mode 5.5.2 YDP04IS-0CE* printer
6. Printing 6.1. Manual/auto 6.1.1 Manual without stability
print mode 6.1.2 o Manual after stability
6.1.3 Automatic without stability
6.1.4 Automatic at stability
8. through 9. See next page
* = To operate the YDP04IS-0CE, also configure the following menu codes:
– 5.1.7 “9,600 baud”
– 5.2.2 ”space parity”
– 5.3.2 “2 stop bits”
– 5.4.2 “hardware handshake, 2 characters after CTS”
1st Menu Level
2nd Menu Level
3rd Menu Level
Factory Setting
Menu Item