Operating instructions

Preparation
A circle displayed in the upper right-hand
corner indicates that the balance/scale has
been disconnected from power (the power
cable was unplugged or due to power failure).
● Turn on the balance/scale: Press e
> All symbols on the display light up briefly.
> The balance/scale performs a display test.
● To change configurations: see the chapter
entitled “Configuration"
● To load factory-set default configurations:
see “Configuration" (menu code 9 - -1)
$ To tare the balance/scale: Press t
When the balance/scale is switched on,
the b is displayed until you press a key.
If the b symbol is displayed during
operation, this indicates that the processor
is performing a function and cannot receive
further commands at the moment.
Additional Functions
● Turning off the balance/scale: Press e
A zero in the lower left-hand corner
indicates that the balance/scale has been
switched off and is in stand-by mode.
Filter Weighing with Model CP2P-F
The CP2P-F filter microbalance comes with
a filter pan that has a utilizable diameter of
125 mm as standard equipment. Place the
filter on the pan and close the lid.
17