Operating instructions

61
Software Handshake
The software handshake is controlled
via XON and XOFF. When a device
is switched on, XON must be transmitted
to enable any connected device to
communicate.
Data Output by Print Command
The print command can be transmitted
by pressing p/r or by a software
command (Esc P).
Automatic Data Output
In the “auto print” operating mode, data
is output to the interface port without
a print command. You can choose
to have data output automatically at
defined print intervals with or without
the stability parameter. Whichever
parameter you select, the data will be
output as the readouts appear on the bal-
ance/scale display. The display update
frequency depends on the settings for
“Adapting the filter” (1 1 x) and “Time-
dependent automatic printing” (6 3 x).
If you select the auto print setting, data will
be transmitted immediately the moment you
turn on the balance/scale.
In the operating menu, you can define
whether automatic printing can be stopped
by pressing p/r.
Faster Output Speeds
If you require output speeds faster than 10 Hz,
please contact Sartorius for information.