Operating instructions

Getting Started
Fastening the Display and Control Unit to the Front of the Weighing Platform
§ Turn the scale over and place it on a cushioned surface to prevent damage to the
weighing system
§ Remove the column retainer from the scale
§ Fasten the display and control unit retainer to the display and control unit using
the 2 Phillips head screws supplied (1) (M4+ 8)
§ Fastening the retainer to the scale: Fasten the retainer to the scale using the
Phillips head screws supplied (2) (M4+ 8)
§ Press the cable into the raceway (channel)
§ Replace the cover on the cable raceway (1)
§ Close the 4 bore holes using the caps supplied (2)
Remote Operation of the Display and Control Unit
§ Turn the scale over and place it on a cushioned surface to prevent damage to the weigh-
ing system
§ Remove the column retainer from the scale
§ Close the 4 bore holes using the caps supplied (2)
> Cable length: at least 80 cm (approximately 31 inches)
§ To order a longer cable, see the section entitled “Accessories”
Adjusting the Angle of the Display and Control Unit (only with Accessory YDH01F)
§ Tilt the display and control unit to the desired position and tighten the knurled thumb
screw to hold it in place.
10