Operating instructions

Operating Design
Text Input
§ To enter numbers:
see the section on “Numeric Input”
§ To enter letters or characters:
press the a key
> Letters are displayed in the bottom line
for selection
● To select a different letter: press the
corresponding soft key to change the
letter shown
● To select the letter|character shown:
press the corresponding function key
below the soft key label
> The selected letter is shown on the
display
$ Enter the next letter|character, if
desired, as described above
$ To exit the letter input mode
(e.g., if the last character entered is
a letter): press the a key
● To store a word: press the corresponding
function key (soft key), such as
ID
● To delete an input character by
character: press the c key
● To delete user data: enter . or a
space and save
Function Keys (Soft Keys)
The current function of soft keys is
indicated in the bottom line of the
display (footer).
Texts (abbreviations) or symbols can
be displayed.
Texts (Examples)
Cal: Start calibration | adjustment
S ID: Save ID
The function keys are numbered from
right (F1) to left (F6).
Symbols
The bottom line shows the following
symbols:
oo Back to the initial state
(in the Setup menu: exit Setup)
o Go to the higher selection level
O Show sub-items under the active
item
Q Move upward in the input |
output window
q Move downward in the input |
output window
l Set the selected menu parameter
Labeled Keys
These keys always have the function
indicated, but are not available at all
times. Availability of these functions
depends on the current operating status
and menu settings.
There are two fundamentally different
types of display:
– display for weights and calculated
values
– display for menu parameter settings
(setup)
F6 F5 F4 F3 F2 F1
Operation
Display for Weights and
Calculated Values
This display is subdivided into 9 areas.
Line for Metrological Data:
When the scale is used in legal metrology,
the following metrological specifications
of the scale are shown here:
Max Maximum capacity (upper range
limit) of the scale
Min Minimum capacity (lower
range limit) of the scale
R1 Display when e = d
to
R4
e Verification scale interval
d Readability | scale interval
On standard scale, only
Max and d are
displayed.
Line for metrological data
Bar graph
Measured value line
Text line
Soft key labels
Plus/minus sign Unit
Stability indicator Tare memory
Calculated value
Application pictograms
4